LF,
The
503.700KHz beacon upload at http://myweb.tiscali.co.uk/wgtaylor/grabber3.html
has been interrupted due to a critical Internet Security update relating to the
Conficker Worm. The trace has now restarted.
Gary –
G4WGT.
Andy,
No one
will be able to use red-2, green-2 or blue-2 as Rik OR7T is sending his call
sign QRS starting in blue-1 for 7.5 minutes a little low on 503.686KHz.
I
believe he only needs a short CW signal within the blue minute.
Gary
– G4WGT.
By installing a second copy of GB3RAL in another directory (folder) it
is possible to run both instances at once from the same soundcard.
Offsetting the timing differently on each allows six time slots to be
monitored.
Who will bid for red-2, green-2 and blue-2? The first to do so
can dictate their preferred timeslot.
2009/4/1 Rik Strobbe <[email protected]>
Dear all,
I just started a QRSS10 beacon on 503.7kHz (right now 503.705 but it might
drift down some Hz over the next hours).
The beacon will start every 15 minutes at +6 minutes (so xx:06, xx:21, xx:36
and xx:51) and the message takes about 7,5 minutes.
>From +6:25 to +6:30 it will be "key down" for the "blue
trace" on the G4GWT beacon monitor.
ERP is about 200mW
73, Rik ON7YD - OR7T
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
