No Graham... it is in your CMOS boot set-up....you should be able to adjust
the PCI bus speed, or perhaps the clock divider speed that the bus clock is
based on....73...Jordan....
----- Original Message -----
From: "Graham" <[email protected]>
To: <[email protected]>
Sent: Thursday, February 26, 2009 9:51 AM
Subject: Re: LF: Re: wspr and the over clocked sound card .. whats the final
position ??
Jordan
... Er no .. but what to set and what to adjust .?. I assumed the clock
was on the sound card .. small xtal oscillator ?
Tnx
G ..
--------------------------------------------------
From: "Jordan" <[email protected]>
Sent: Thursday, February 26, 2009 1:08 AM
To: <[email protected]>
Subject: Re: LF: Re: wspr and the over clocked sound card .. whats the
final position ??
Have you tried adjusting the PCI bus settings in CMOS..?
----- Original Message -----
From: "Graham" <[email protected]>
To: <[email protected]>
Sent: Wednesday, February 25, 2009 5:09 PM
Subject: Re: LF: Re: wspr and the over clocked sound card .. whats the
final
position ??
Jordan
The card is a PCI , M - Audio Delta 4
running with windows xp-pro
There are a selection of clock speeds .. but it seems that when a
application runs . it defaults to the 44k setting .. but for all other
software .. no problem .. works very well
G ..
--------------------------------------------------
From: "Jordan" <[email protected]>
Sent: Wednesday, February 25, 2009 11:59 PM
To: <[email protected]>
Subject: LF: Re: wspr and the over clocked sound card .. whats the
final
position ??
Is this for an on-board sound card, and if not, what type of bus is it
on..?
73...Jordan....
----- Original Message -----
From: "Graham" <[email protected]>
To: <[email protected]>
Sent: Wednesday, February 25, 2009 4:50 PM
Subject: LF: wspr and the over clocked sound card .. whats the final
position ??
wspr and the over clocked sound card
Was there a resolve to the problem of the short wspr tx produced by
a
soundcard that was running slightly faster than it should
1.5 seconds short ..... about 1 %
, resulting in no decodes for strong signals .. presumably by
providing
too many sync's
There is no way of changing the sample rate of the card .. there is
a
option in the driver . but as soon as wspr runs . the card reverts
to
the normal 44 khz setting
No problems with any of the other systems as the card can be
calibrated
(though not needed)
any fixes or ideas ??
tnx
Graham ..
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.3/1971 - Release Date:
02/25/09
06:40:00
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.3/1971 - Release Date: 02/25/09
06:40:00
|
