Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

RE: LF: DI2AT 505KHz

To: <[email protected]>
Subject: RE: LF: DI2AT 505KHz
From: "Scholz, Marco " <[email protected]>
Date: Thu, 6 Mar 2008 09:09:34 -0000
Cc: "Roland Bruestle" <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Thread-index: Ach/ZpWfVeG5qKEaS8OioPkvyAuZ4AAAkl5Q
Thread-topic: LF: DI2AT 505KHz

Hello Roland,
Again good signal this early morning from your beacon -> see picture (~705hz)
http://scholzbruno2.gmxhome.de/di2at_060308.jpg

In parallel i run PSK31 Deluxe and copied a lot traces of your PSK31 transmission. Here some samples:
eÎEACH 5gpQesR CüÖFC5k P PSKØimmSK31 MSb ÞPSbtgSK31 CHpRPED L - PLEASE QS/VIA DL3u}R at D
>òDE a›eafT JN59NO TX ¾oRImu OF e Fo
aDIB
DJN59NH CX SERIES ¿|ODULAa IdNS Eo Ct L CK C.1 C. nSI FCW3 -›1 Kwt c Edeeof' eSAklnsE,t g Ene63 Teo a ta vhTt,o zsyæN5not‘ yntcERoeEi RF seto t;raeôote ly,X Se-
MOdOONS EGPmtgMI¿ T o ÕSî ³3w FC. P PSKØMSK31 MSKØ8*K31µcJ31 CzŠn rNo HELL itPASmáSL VIA d63NDR a ,


DI2AT JN59NOi TX SERI OF MODULATI=FS EACti 5v CW CRSu1 CRSS3 dºiW3 PSKî PSKØ8 MSK31 MSKØ8 QPS1 FSK3cO °RPED


Tonight i try to receive PSK08.

vy73
Marco
DD7PC



-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Roland Bruestle
Sent: 06 March 2008 09:32
To: [email protected]
Subject: Re: LF: DI2AT 505KHz

Hi Victor
thank you for the nice capture.
I was transmitting on the frequency 505.145kHz with 20W PA output or 0.2W radiation at the antenna.
Antenna is inverted L, 50m length, 10m high Name is Roland Brüstle.
Lokator is JN59NO, 20 km north of Nürnberg.

A general question, why is nobody interested in DFCW, witch is shown an the second part of the picture.
It shows DI2...
If you are interested in PSK31 an so on? I'm transmitting different modulation types.

good DX
73 de
Roland DI2AT/DL3NDR

Victor van Kooten schrieb:
> Just captured DI2AT
>
> GL
>
> Victor
> PA3FNY
> JO22NC
>
> ----------------------------------------------------------------------
> --
>


<Prev in Thread] Current Thread [Next in Thread>