Hi all the only trouble is that a lot of us use LSB on 136 to drop DCF39
over the edge of the filter.......this results in and upside down
message....literally.
How do you use the Spectran frequency scale when you are on LSB?
If you tune the receiver to 137kHz USB then the scale on Spectran is meaningful
For example 137kHz on the Rx, plus a Spectran reading of 600 = 137.600kHz.
The receiver is set to SSB bandwidth and any strong out of band
signal can be attenuated using the IF SLOPE TUNING.
This seems simple to me - but is there a better way?
The TS-850 has a 1Hz tuning resolution but a 10Hz readout resolution.
The fix is the set the receiver frequency at the point where it
changes from 136.99 to 137.00.
--
Regards, Peter, G3LDO
<[email protected]>
| 