Hi Chris, This would be possible but more or less lossy. What is the impedance as seen by your AIM when you measure on the secondary side of the 1:1 isolation transformer with antenna and feeder conn
Hello Clemens, I'll do some testing tomorrow, been trying to gain a bit of vertical height today and have run out of "play time". Just to be sure, you want me to reverse the connections so the AIM is
Hi Chris, Just to be sure, you I'm not sure if I understand your description correctly so I try with a block diagram. Is it like this? TRX - short coax - autotransformer - longer run of RG-213 - isol
Hello Clemens, No it's assembled like this: 2 X amps to combiner via 2 off 12 inches Teflon coax cables : Combiner to LPF via 12 inches Teflon co-ax : Combiner to outside about 40 feet RG-213 co-ax :
Hello Clemens, It is between the outdoor end of the RG-1213 co-ax and the loading coil, although it's not 1 : 1 at the moment, it has taps on the primary and the secondary to fiddle with. -- Best reg
Hi Chris, ok, I hope I have now understood your set up and what you may possibly want to change. Present configuration: And from an earlier post by you: So you want to modify the combiner-autotransfo
Hello Clemens, Thanks for the reply, I have posted a link to photos at http://www.gatesgarth.com/radio.zip that show the outside stuff. Perhaps that will make the set up a bit clearer. I seem to be b
Hi Chris, In my first reply from 24.6.2017 "This would be possible but more or less lossy" it was not clear to me that you would possibly like to tap the transformer *of the combiner* and that the LP