Hello Stefan, Spiros,
indeed, I messed up the waterfall display a bit, this will be fixed in the next
release.
It can be more or less corrected by
- setting the offset close to 0 (click close to the bottom of the spectrum
display, the red line right of that display should move down)
- setting the gain rather high
But the messed up waterfall display will NOT affect decoding.
73, Rik ON7YD - OR7T
________________________________________
Van: [email protected] <[email protected]>
namens DK7FC <[email protected]>
Verzonden: zaterdag 12 januari 2019 20:46
Aan: [email protected]
Onderwerp: Re: LF: SV8CS SlowJT9-10
Hello Spiros, Rik,
Unfortunately the new slowJT9 version does not work here, probably.
The program does not crash. I can see some noise in the spectrum view.
The audio level is jumping arround 50 dB, quite in the center of the
left slider. The spectrum gain is however almost dark, although the gain
slider is pushed to the maximum. RX frequency is 136.000 kHz + the
typical range. I got good decodes in WSPR-15 from IW4DXW and DL7NN in
WSPR-2 from the same audio source. But there are no slowJT9 decodes yet.
My TX is driven from a different PC than the RX, so i have to run 2
separate instances of slowJT9. Maybe i can decode my own signal ;-)
I will give it a try on 136.390 Hz soon. My antenna will be totally
detuned, so the antenna current will be very low on that frequency.
Maybe the signal makes the path to Rik.
Spiros, if this all does not work here, do we want to try in the normal
JT9-1 mode? I remember you were strong enough. I would then go to
137.390 Hz, later. But first, one run in -10.
73, Stefan
Am 12.01.2019 19:24, schrieb SV8CS-Spiros Chimarios:
> Hi to All.
> I am TXing now JT9-10, + 415Hz - 1st period dial USB 136 KHz.
> Reports are welcome.
> Waiting for Stefan DK7FC for the sked, this evening.
> Also Received many times R7NT on 136 KHz JT9-10.
> 73, Spiros/SV8CS
>
>
|
