Hello  LF'ers.

 Hi, I run a fairly odd set up. TS-590 in split mode, TX'ing at 272 kHz
from the DRIVE socket into a 1kW amp which by design halves the
frequency. I use the X2 function in WSJT-X to give the correction
needed. On RX I receive on 136kHz dial frequency.

I use the 590's RX antenna socket for reception and use the same
antenna for RX and TX. I use a home built antenna change over box
using a high power Russian coaxial relay. This has a 20mS change over
time. The maximum delay I can put in the 590 menu for TX delay is
20mS. Can I use the WSJT-X TX delay to add 0.5 seconds of delay before
RF is issued from the amp to give more time for the relay box to
change antenna from the RX Antenna socket of the 590 to the DRIVE
socket?

Thanks,  I  hope  the above is clear enough! Ask for any clarification
please :)

2E0ILY

-- 
Best regards,
 Chris                          mailto:[email protected]