|
Hi Stefan,
ok, that would be nice! For your TX setup, you'll
probably need to make VAC the default audio output and then upconvert with a
SpecLab instance.
This mode is fast! Normally I type something
to the keyboard and then leave the room to get some coffee or read or do
something else. Now I before I even turn my head, the message has
been sent already and the TX is sitting idling away ;-)
73, Markus
Sent: Tuesday, February 11, 2014 11:15 PM
Subject: Re: LF: RE: WSQ,A Weak Signal QSO mode for
LF/MF
Hi
Markus,
I'm just reading. Maybe i'll give it a try soon (today) but
still not sure. Stay on air if you have the time :-)
73,
Stefan/DK7FC
Am 11.02.2014 22:24, schrieb Markus Vester:
Hi Steinar, Rik,
sounds like fun! Would you like to try to listen
on LF ?
The audio band in the WSQ software seems to
be fixed at 1000 Hz, and my LO (dial) is also fixed to 135.5 kHz. So I
will attempt to transmit around 136.5 kHz (RF) in a few minutes from
now. Due to lower than normal antenna height, my ERP will be only about
0.2 watts or so.
Best 73,
Markus (DF6NM)
Sent: Tuesday, February 11, 2014
8:59 PM
Subject: Re: LF: RE: WSQ,A Weak
Signal QSO mode for LF/MF
Hi Rik
I have no TX antenna at the moment
. I am only able to RX
S la5vna
Sent: Tuesday, February 11, 2014
7:11 PM
Subject: LF: RE: WSQ,A Weak Signal
QSO mode for LF/MF
|
|
