Hello Peter, Markus,
In the past it was shown that the best solution is, if you need some
help, to install Teamviewer software and allow me or Markus to make a
session on your PC. Because there are individual settings, depending on
your samplerate, folder names, FFT settings and so on. However there are
some basic instructions in Markus' help file.
The advantage of OPDS4H on 8970 Hz is that you can use your existing SL
grabber instance to generate the data set. You don't need to start a
separate SL instance then. Additional CPU load is very low then, which
helps to avoid phase glitches during the 4 hour period, which is essential!
73, Stefan
Am 01.01.2014 13:12, schrieb PA1SDB, Peter:
Hello Stefan, Markus, Uwe.
I did not follow all mailings here, but just now OPDS is under my
attention.
I have to learn a lot in short time about this mode ans settings.
Is it possible to send me the 8970 .usr files Stefan.
Not at home these day's so I can't RX on very short time.
Uwe, I'm still listening in OPERA 4H 8.0 and I did decode my own test
broadcast, but no sign of your signal Uwe.
Perhaps QSY tot 8970 agan in OPDS4H mode ? Seemt to work :-)
73's and Happy new Year to you all.
Peter - PA1SDB
----- Original Message ----- From: "Stefan Schäfer"
<[email protected]>
To: <[email protected]>
Sent: Tuesday, December 31, 2013 6:18 PM
Subject: LF: DF6NM n OPDS4H detected on the 33km band
Hi all,
I'm excited. Just seen that Markus successfully has been detected
here in OPDS4H.
2013-12-31 18:07:58 DF6NM 175km 8970.000Hz 0mHz -58.3dBOp 100% 17.0dB
http://www.iup.uni-heidelberg.de/schaefer_vlf/DK7FC_VLF_Grabber2.html
73, HNY
Stefan/DK7FC
|
