Hi Claudio,
Thanks in advance.
In fact the OD is 25.6 mm (measured). So 26 mm may be the 'nominal' value.
The markings on the core have almost been wiped off, but besides the
"N28", there is another marking "1200" which may be the AL value in
nanohenry.
As a layman's test, I wound 3 turns on the core and exposed it to a 20
Vpp sinewave for a minute, and it didn't seem to get warm (about 9 uH).
So for a transformer it may be ok.
Cheers,
Wolf .
Am 20.07.2013 15:56, schrieb Claudio Pozzi:
On Saturday 20 July 2013 14:50:27 you wrote:
Greetings all,
Does anyone have old databooks of Siemens (now Epcos) ferrite materials
at hand ?
I'm looking for information of N28 material, after discovering a bunch
of pot cores in the junkbox.
25 mm diameter, 16 mm height, and an AL value of approx. 1 uH per turn
squared.
The label carries the 'Siemens and Halske' logo, so these cores must be
quite old.
The plan is to use one of them as transformer to feed the gate of a
MOSFET which requires floating ground (source not connected to GND, but
to the drain of another MOSFET).
Is this old N28 material usable at a few hundred kHz, and what about the
max flux in the core / max density / saturation ?
Best regards,
Wolf DL4YHF .
I have a Siemens data book with all data but the pot cores are 26x16 mm. If
you confirm the diameter 26 I take some pictures an send you.
73 de Claudio IK2PII
--
Caselle da 1GB, trasmetti allegati fino a 3GB e in piu' IMAP, POP3 e SMTP
autenticato? GRATIS solo con Email.it http://www.email.it/f
Sponsor:
ANGRY BIRDS: Acquista Peluche e Gadget Originali su mistercupido.com
Clicca qui: http://adv.email.it/cgi-bin/foclick.cgi?mid=12900&d=20-7
|
