Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: JT9-10 on 137.42 kHz

To: <[email protected]>
Subject: LF: Re: JT9-10 on 137.42 kHz
From: André Guyé <[email protected]>
Date: Thu, 22 Nov 2012 16:09:07 +0100
Importance: Normal
In-reply-to: <[email protected]>
References: <[email protected]> <[email protected]> <E36D7D5CB83D43018EE1A765F4C67435@F6CNIHP> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Il faut toucher dans le “Wide Graph” le bouton tout en bas et à gauche de “FFT Bins/Pixel” et choisir par exemple la valeur 6...
 
Sent: Thursday, November 22, 2012 4:02 PM
Subject: Re: LF: Re: JT9-10 on 137.42 kHz
 
Non Andre',
malheureusement le mode JT-10 permet seulement l'offset de 1000 a 1100 Hz .. pas outrement !...
j'ai place' maintenant 136.4 KHz dial et 1020Hz de Offset.

73  de Mauro IK1WVQ



At 15.49 22/11/12, André Guyé wrote:
The dial USB is 136.000 and the TX offset is + 1420 Hz.
 
73.
 
From: IK1WVQ Mauro
Sent: Thursday, November 22, 2012 3:45 PM
To: [email protected]
Subject: Re: LF: JT9-10 on 137.42 kHz
 
HI ,
137.42 is the DIAL frequency ?? what offset ???
73 de Ik1WVQ

At 15.15 22/11/12, you wrote:
LF!!!

I'm running some JT9-10 on 137.42 kHz. So far we concentrated to JT9-1...JT9-2, as suggested by Joe. However the program may be very suitable for serious data mode DX on LF/MF after fixing some bugs.

I'm running only 5W TX power, later, when the band opens for DX i may rise the levels by some dB. I do not expect timing of frequency drift problems from my side.

Reports apprechiated :-)

If there is some interest on the TA side, i may run this over the night as well.

73, Stefan/DK7FC

Nessun virus nel messaggio in arrivo.
Controllato da AVG - www.avg.com
Versione: 9.0.930 / Database dei virus: 2441.1.1/5410 -  Data di rilascio: 11/21/12 21:05:00

Nessun virus nel messaggio in arrivo.
Controllato da AVG - www.avg.com
Versione: 9.0.930 / Database dei virus: 2441.1.1/5410 -  Data di rilascio: 11/21/12 21:05:00
<Prev in Thread] Current Thread [Next in Thread>