Oh, i just remember and see that JT9-10 is intended to run on
1000...1100 Hz audio frequencies. However the bandplan says that
digimodes are at 137.4...137.6 kHz.
So one has to change to 5 FFT bins/pixel to reach 1420 Hz anyway or
simply choose 136.4 kHz "dial" and set the center frequency to 1020 Hz.
73, Stefan/DK7FC
Am 22.11.2012 15:45, schrieb IK1WVQ Mauro:
HI
,
137.42 is the DIAL frequency ?? what offset ???
73 de Ik1WVQ
At 15.15 22/11/12, you wrote:
LF!!!
I'm running some JT9-10 on 137.42 kHz. So far we concentrated
to
JT9-1...JT9-2, as suggested by Joe. However the program may be very
suitable for serious data mode DX on LF/MF after fixing some
bugs.
I'm running only 5W TX power, later, when the band opens for DX i may
rise the levels by some dB. I do not expect timing of frequency drift
problems from my side.
Reports apprechiated :-)
If there is some interest on the TA side, i may run this over the night
as well.
73, Stefan/DK7FC
Nessun virus nel messaggio in arrivo.
Controllato da AVG -
www.avg.com
Versione: 9.0.930 / Database dei virus: 2441.1.1/5410 - Data di
rilascio: 11/21/12 21:05:00
|
|