Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: MF tonite BSK8

To: <[email protected]>
Subject: Re: LF: MF tonite BSK8
From: "Graham" <[email protected]>
Date: Thu, 13 Sep 2012 23:44:26 +0100
Importance: Normal
In-reply-to: <000001cd91fd$3dd009d0$b9701d70$@com>
References: <[email protected]> <[email protected]> <F2C19D7523C24D559473A7B02F21F6FF@AGB> <[email protected]> <7222786F66254418BD8BF47B0162417E@AGB> <[email protected]> <8B9EF7CC1E2D4558B4EA0DFDE6BB70E1@AGB> <02a101cd91ee$8cd55e90$a6801bb0$@com> <[email protected]> <000001cd91fd$3dd009d0$b9701d70$@com>
Reply-to: [email protected]
Sender: [email protected]
Not  bad  Terry  !
 
Only  very low  traces showing  on g4wgt  grabbers  at the  moment ,
 
G.

Sent: Thursday, September 13, 2012 11:15 PM
Subject: RE: LF: MF tonite BSK8

Now getting PSK31 decodes – not solid copy but it’s a copy!!

 

73 Terry

 

From: [email protected] [mailto:[email protected]] On Behalf Of Roland Bruestle
Sent: 13 September 2012 22:16
To: [email protected]
Subject: Re: LF: MF tonite BSK8

 

Terry,
could you decode PSK8?
I switched back to PSK31.
On my control receiver es was hart to decode PSK8.
Will do some more tests.

73
Roland



Am 13.09.2012 22:29, schrieb Terry GW0EZY:

Graham

 

Just found it – it is in SpectrumLab – Digimode terminal

 

73 Terry

 

From: [email protected] [mailto:[email protected]] On Behalf Of Graham
Sent: 13 September 2012 21:08
To: [email protected]
Subject: Re: LF: MF tonite BSK8

 

 

''sounds good''.   This  is the  INVISIBLE   ROS that  spooked MAL  hihi

 

If you can  here  mf-2  , then the  power  is  too  high  . Gerhard dk6ni  uses this  mode , you  might  have  qso

could be the  first  data  qso on the  new  band  ?

 

I don't see  any  signal  on the  web-sdr , looking  at 475 , small  trace  hf  , but  what  software  has  psk8 ?

 

73-G..

 

 

 

Sent: Thursday, September 13, 2012 8:48 PM

Subject: Re: LF: MF tonite BSK8

 

Graham,
sounds good.
Let me have a look at it and then a test.
May be I  can do it to morrow.
Today, I am transmitting PSK8.

73
Roland

Am 13.09.2012 19:06, schrieb Graham:

Ok Roland

 

That's  a  good  Tx  system  !  much smaller  than  my   Racal  MA1723

 

If you  have  SDR  then  the  ros-mf  data  modes  can be  used directly  with  SDR   , very little  use  has  been made of them  due to the  need for  audio>rf  or  sdr  Tx  drive  ..or  by  using  Transverter

 

These  modes  are  100 Hz B/W    MFSK   ,  MF-2  is the  same  s/n as  wspr  and  MF-7  , the  same data  rate  as  psk32 , but  some  10 to 12 dB  lower s/n ...part of the  ROS data  package  , download  the  same  site  as opera

 

This  was  nearly  a  mistake  as  Joe has the  Rx  set to 7  only  , so  when I switched  to  MF-1  , decodes  stopped , the  MF-7  was a  warm-up  test  !

 

 

Good  luck  with the  trials

 

73-G..

 

Sent: Thursday, September 13, 2012 5:31 PM

Subject: Re: LF: MF tonite BSK31

 

Graham,
I am using a Soft Rock SDR transceiver.
I modified a Soft Rock SDR 160m to 500kHz.
 Additionally I am using a CB PA changed to 500kHz with 80 W output. Ok, this is not very linear.
That's means any modulation mode is possible. Why are you asking?

73
Roland

Am 13.09.2012 17:32, schrieb Graham:

Roland

 

Do you  have  transvertor ? can  use  any  audio  based mode ?

 

G..

 

Sent: Thursday, September 13, 2012 3:17 PM

Subject: LF: MF tonite BSK31

 

hello MW,
I am transmitting PSK31 on the transmitting frequency 475kHZ (not dial).

It's mainly a test. It's the first PSK31 transmission with this equipment.

73
Roland DL3NDR

 

 

 

<Prev in Thread] Current Thread [Next in Thread>