''sounds good''. This is the
INVISIBLE ROS that spooked MAL hihi
If you can here mf-2 , then the
power is too high . Gerhard dk6ni uses this
mode , you might have qso
could be the first data qso on
the new band ?
I don't see any signal on the
web-sdr , looking at 475 , small trace hf , but
what software has psk8 ?
73-G..
Ok Roland
That's a good Tx system
! much smaller than my Racal MA1723
If you have SDR then
the ros-mf data modes can be used directly
with SDR , very little use has been made
of them due to the need for audio>rf or
sdr Tx drive ..or by using Transverter
These modes are 100 Hz
B/W MFSK , MF-2 is the
same s/n as wspr and MF-7 , the same
data rate as psk32 , but some 10 to 12 dB
lower s/n ...part of the ROS data
package , download the same site as opera
This was nearly a
mistake as Joe has the Rx set to 7 only ,
so when I switched to MF-1 , decodes stopped ,
the MF-7 was a warm-up test !
Good luck with the trials
73-G..
Sent: Thursday, September 13, 2012 5:31 PM
Subject: Re: LF: MF tonite BSK31
Graham,
I am using a Soft Rock SDR transceiver.
I modified a Soft Rock SDR 160m to 500kHz.
Additionally I am
using a CB PA changed to 500kHz with 80 W output. Ok, this is not very
linear.
That's means any modulation mode is possible. Why are you
asking?
73
Roland
Am 13.09.2012 17:32, schrieb
Graham:
Roland
Do you have transvertor ? can
use any audio based mode ?
G..
Sent: Thursday, September 13, 2012 3:17 PM
Subject: LF: MF tonite BSK31
hello MW,
I am transmitting PSK31 on the transmitting
frequency 475kHZ (not dial).
It's mainly a test. It's the first PSK31
transmission with this equipment.
73
Roland
DL3NDR
