Re: LF: QRSS30 QRPp beacon approx 137.770kHz - Frequency Check

[Roger Lapthorn <rogerlapthorn@gmail.com>]

Very many thanks Dave. The signal actually looks pretty strong (!) and the frequency information is most useful.

73s
Roger G3XBM

On 5 May 2011 21:40, Dave G3WCB. <ganymede444@btopenworld.com> wrote:

Hi, Roger.

 

I measure your frequency to be 137 767.9 Hz - a bit low of 137 770. On the attached screen shot, you can see your signals, my local 137770 signal apparently 0.3Hz high, and two Loran lines.

 

Your signals are good copy here tonight. There's very little QRN, and the band seems to be in good shape.

 

73, Dave G3WCB IO91RM

 

-----Original Message-----
From: owner-rsgb_lf_group@blacksheep.org [mailto:owner-rsgb_lf_group@blacksheep.org]On Behalf Of Roger Lapthorn
Sent: 05 May 2011 17:21
To: rsgb_lf_group@blacksheep.org
Subject: Re: LF: QRSS30 QRPp beacon approx 137.770kHz - reports appreciated

Hi Stefan (et al)

Using the readout I have (nearest 10Hz on my FT817 and IC703) it is very close to 137.770kHz by zero beating the signal. It would be helpful to get a semi-local with accurate frequency calibration to confirm the exact frequency. I may try measuring the offset from one of the strong commercial signals and see if I can get a closer figure although I am going away for a week so this will have to wait until I get back.

QRSS60 would be too wobbly with the crystal/divider arrangement I currently have. Even QRSS30 was marginal (wobbly) with G3WCB and PA3CPM. At the moment the beacon board is just sitting on the desk in the open air and I suspect the crystal frequency moves a few Hz (before division) as I wave my arms typing this. There is also temperature drift as the PA keys on. All can be much improved.

F1AFJ is not in the best direction for the loop antenna, but I am an optimist.

73s
Roger G3XBM

2011/5/5 Stefan Schäfer <Stefan.Schaefer@iup.uni-heidelberg.de>

Hello Roger,

What means close? Is it above 770 so i am looking for you :-) Maybe the first RX stations can confirm the actual frequency, if unknown so far.

73, GL, Stefan

PS: QRSS60 would be more useful for all the grabbers. I see a goog chance that you can appear at F1AFJ!


Am 05.05.2011 15:27, schrieb Roger Lapthorn:

My QRSS30 50uW beacon XBM (space then G3XBM at 10wpm) is now active on its new frequency close to 137.770kHz until 2300z this evening. As always, reports and screen shots would be very much appreciated.

If trying to copy it, very best of luck.

73s
Roger G3XBM

--
http://g3xbm-qrp.blogspot.com/
http://www.g3xbm.co.uk
http://www.youtube.com/user/g3xbm
https://sites.google.com/site/sub9khz/

--
http://g3xbm-qrp.blogspot.com/
http://www.g3xbm.co.uk
http://www.youtube.com/user/g3xbm
https://sites.google.com/site/sub9khz/

-- 
http://g3xbm-qrp.blogspot.com/
http://www.g3xbm.co.uk
http://www.youtube.com/user/g3xbm
https://sites.google.com/site/sub9khz/