|
Call me on CW when you next hear me for further discussion
, its quicker than QRS.
I am disappointed that you cannot supply me with some
measurements since you have the necessay calibrated equipment.
I will decide the validity of your erp measurements when I
get the result, if you are an expert they should be accurate.
I am now QRV on 502.5 CW and await some erp measurements
from you.
G3KEV
----- Original Message -----
Sent: Wednesday, February 16, 2011 3:57
PM
Subject: RE: LF: TA TONITE
Mal,
You
will just have to wait then.... I certainly have both the
equipment and the antennas (both calibrated) needed
to measure field strength available to me but you have
already said that my measurements would be meaningless and disparaged both my
ability and qualifications - as well as those of others. So NO I will
certainly not bother with your transmissions or, indeed, pursue this
subject further as my expectation of your response has been borne
out.
Paul G8GJA
Radio amateurs do not have suitable calibrated
equipment, suitable antennas nor in most cases the expertise to carry out
these measurements.
Can you measure my ERP ? and if so what is
it ?
From your statement I assume you are an expert
and qualified to make these measurements.
I am frequently on 137.7 and 136.318 I now await
your observations.
G3KEV
----- Original Message -----
Sent: Wednesday, February 16, 2011
3:24 PM
Subject: RE: LF: TA TONITE
Mal,
The reference ...'especially by Radio Amateurs' could
well be considered offensive and is definitely not borne out by fact. I
suppose that the only qualified people would be marine radio
officers?
I will not request a retraction - knowing you it would not be
forthcoming - but could you be a bit careful with sweeping generalisations
in the future?
Paul G8GJA
Toni
It is all Guesswork trying to measure ERP some
hundreds of miles away. especially by Radio Amateurs.
I have seen figures in the past and after a
detailed mathematical analysis the concluded statement was that this
could be 6 dB either way, in other words the erp measured could be
1W erp or maybe 4w erp or even worse a lot less.
Let them believe what they like hi
g3kev
----- Original Message -----
Sent: Wednesday, February 16,
2011 1:08 PM
Subject: Re: LF: TA TONITE
Thanks Rik
I've read somewhere that DCF39 has 40kW
EIRP. So we would have around 4W EIRP. Last week a station measured
our field strength, 100km away and came to 0.4WEIRP. This is probably
a little bit to low. Anyway, it shows me again, that most amateurs
overestimate their ERP. Even Mal has probably not the Watt he claims
;-)
73 de Toni
2011/2/16 Rik Strobbe <[email protected]>
Hello Toni, group,
I measured
the HE3OM signal 41dB down
on DCF39.
Distances to HE3OM (504km)
and DCF39 (515km) are almost identical.
This might give the US stations a clue
what signal strength they can expect from HE3OM and what QRSS speed
Tony could use to be copied.
73, Rik ON7YD
Dear Jim, Mal and LF Group Unfortunately the tower is
not nearby my house and I can't leave the station running
unattended. And the nights I can spend in Sottens are limited by my
health and my wife, hi. So there is no trial before, I have just
next Friday night. If I take a look at the reports we got in the
past two weeks from stations 2000-3000km away (always good audible),
it should be possible to span 6000km using QRSS10. On the
receiving side, we may be able to see stations let's say with
QRSS60. This would mean, that we could make only one or two QSO's.
May be it's better to try Crossband: we transmit in QRSS10 and
listen on 80m. This would give more stations the opportunity to
contact us. However, if there is a station from the East Coast we
copy in QRSS10 it would get the priority. What do you think about
this approach? 73 de Toni
2011/2/15 James Moritz <[email protected]>
Dear
Toni, LF Group,
HE3OM has the advantage of a much stronger
TX signal than most Eu stations, so I guess you have a good chance
of being copied in NA on Friday night, unless the propagation is
very poor. But as you will have seen from the activity last
weekend, forward planning is always a good thing, especially where
a single QSO takes hours. If possible, I would suggest
transmitting some beacon signals from HE3OM between now and
Friday, so that North American stations can get a good idea what
QRSS speed can be copied from your station. Also, try to receive
any W/VE beacons that might be running, so that you also know what
the requirement will be in the other direction. Finally, I have
usually found reception of US stations is best just before dawn
here, so make sure you are not going to be busy on
Saturday!
Good luck,
Cheers, Jim Moritz
73 de M0BMU
This email, including any attachment, is a
confidential communication intended solely for the use of the individual
or entity to whom it is addressed. It contains information which is
private and may be proprietary or covered by legal professional privilege.
If you have received this email in error, please notify the sender upon
receipt, and immediately delete it from your system.
Anything contained in this email that is not
connected with the businesses of this company is neither endorsed by nor
is the liability of this company.
Whilst we have taken reasonable precautions to
ensure that any attachment to this email has been swept for viruses, we
cannot accept liability for any damage sustained as a result of software
viruses, and would advise that you carry out your own virus checks before
opening any attachment.
This email, including any attachment, is a
confidential communication intended solely for the use of the individual or
entity to whom it is addressed. It contains information which is private and
may be proprietary or covered by legal professional privilege. If you have
received this email in error, please notify the sender upon receipt, and
immediately delete it from your system.
Anything contained in this email that is not
connected with the businesses of this company is neither endorsed by nor is
the liability of this company.
Whilst we have taken reasonable precautions to
ensure that any attachment to this email has been swept for viruses, we cannot
accept liability for any damage sustained as a result of software viruses, and
would advise that you carry out your own virus checks before opening any
attachment.
|
