Re: LF: Re: Increased ERP on 137.5kHz - WSPR reports please

[Roger Lapthorn <rogerlapthorn@gmail.com>]

My Marconi is just my 28MHz halo and its short coax feed (strapped) fed via an indoors ferrite rod inductor which is tuned and tapped. So most of the current is NOT flowing in the vertical section. I need to set to work on erecting a "real" vertical and a real matching network. There is no excuse.

The loop produces a signal that has been received at 148km (and quite consistently at 46km) despite the low ERP (recalculated as around 200uW based on the current flowing in the loop), so if I can get a more effective vertical, rather than my poor attempt today, there is hope.

73s
Roger G3XBM

2011/1/11 Stefan Schäfer <schaefer@iup.uni-heidelberg.de>

Roger,

Maybe there was a kind of  "utilities assisted earth mode" on the loop at 3 km distance, as you call it? How high is the antenna and where is is placed? I hope its on the roof of the house :-) If its near a wet tree and just 3m long, it may be worse than the loop. How do you measure the resonance? If you measure the antenna current, how high is it?
I think you are on the right way to make your signal detectable in higher distances! Good luck!

73, Stefan/DK7FC

Am 11.01.2011 19:26, schrieb Roger Lapthorn:

So much for the theory then....

The signal level at G6ALB in the next village (3km although WSPR shows it as 0km) is some 10dB down on my loop antenna. Not sure if I got my sums wrong or there is some unexplained loss. The RX system at G6ALB is unchanged.

73s
Roger G3XBM

On 11 January 2011 17:32, Roger Lapthorn <rogerlapthorn@gmail.com> wrote:

Dear All,

Today I rigged up and matched a simple, small, Marconi vertical on 136kHz instead of the vertical loop. Based on measurements of antenna current and some reasonable assumptions of effective height, I now believe I have around 200uW ERP on the band - heck this is high power for me!

>From now until late this evening I will run the WSPR beacon (136kHz USB dial) in the hope that a few more people will be able to copy the QRPp signal. Please have a go and let me have any reports.

73s and good luck

Roger G3XBM

--
g3xbm-qrp.blogspot.com/
www.g3xbm.co.uk
www.youtube.com/user/g3xbm
G3XBM   GQRP 1678    ISWL G11088

--
g3xbm-qrp.blogspot.com/
www.g3xbm.co.uk
www.youtube.com/user/g3xbm
G3XBM   GQRP 1678    ISWL G11088

-- 
g3xbm-qrp.blogspot.com/
www.g3xbm.co.uk
www.youtube.com/user/g3xbm
G3XBM   GQRP 1678    ISWL G11088