Gerhard, Horst,
be careful.
I have a 220W ATX PSU in front of me: the +12V is rated 14A, but the -12V only
0.5A.
But maybe 2 computer PSU's (with the 12V output made floating) can deliver 24V
at > 10A.
73, Rik ON7YD - OR7T
________________________________________
Van: [email protected] [[email protected]]
namens Gerhard Hickl [[email protected]]
Verzonden: dinsdag 7 december 2010 14:36
Aan: [email protected]
Onderwerp: Re: LF: Searching for Power Supply 24V/10A
Hello Horst!
The cheapest way is to obtain 2 computer-power supplies from the
junk-yard (= for free). Then you have to open both, disconnect the
negative supply from earth-potential (but of course NOT disconnecting
the earth from chassis!!!) and connect the 12V supplies in series.
This is simple and cheap!
73
OE3GHB
Gerhard
Am Dienstag, den 07.12.2010, 12:44 +0100 schrieb pa3abk:
> I'm using a Conrad PSU 24VDC @ 10.5A EA-PS 524-11-T from EA - German
> technology made in China ;-)
> Best.-Nr.: 510120 - 62 [Teilenummer: 35 320 133]
>
> Didn't find any spurious yet of MF and HF although using open feeders.
> There is also a sensor available to eliminate the voltage drop over the
> cables.
> It comes with mounting brackets.
> A 48VDC version is available.
> Just check Conrad.de for details.
>
> It's also possible to use the cheaper "mousetrap" PSU's, but as QRM and
> noise is not acceptable I choose for this one.
> The few euro's more doesn't justify the irritation and trouble to
> eliminate the QRM.
>
> Initally I had the TX with unstabilized PSU, because Class E final is
> calculated with a certain voltage and associated L/C result was rather
> irratic.
> This PSU gave me a stable PA 24VDC/5,6A in and over 100W out.
> Jan/pa3abk
>
>
> Op 7-12-2010 11:33, Horst Stöcker schreef:
> > Hello,
> > I am looking for a power supply 24V/10A. Swiching power supply would
> > be the best choice to me.
> > I got a new PA unit for my beacon DI2AN, but without power supply.
> > Power can also be higher (up to 48V).
> > vy73 Horst DO1KHS/DI2AN
> >
> >
>
>
|
