|
Very close to 100 % .. what is
the power level now ??
G .
RX1: <21:15 UTC> <6.8 Hz> /*$F9G4WW
4E424+O9000J \W39Z)CIR+B,$ <CANCEL> <-30 dB>
RX1: <21:50
UTC> <6.8 Hz> TEST G4WGTEG3]Y]O <STOP> <-31
dB>
RX1: <21:55 UTC> <6.8 Hz> TESG4WGT IO83QO
<STOP> <-29 dB>
RX1: <22:00 UTC> <6.8 Hz> TEST
G4WGTOIO83QO <STOP> <-31 dB>
RX1: <22:05 UTC> <6.8
Hz> $ESTQE]WGT+IO83QO <STOP> <-31 dB>
RX1: <22:10
UTC> <6.8 Hz> ]EST G4WGT IO83QO <STOP> <-32
dB>
RX1: <22:15 UTC> <7.3 Hz> :EST G4WGT IO83QO
<STOP> <-31 dB>
Sent: Thursday, April 29, 2010 9:42 PM
Subject: Re: LF: ROS beacon 503.600kHz
LF,
Not able to reply to any calls from now but the beacon will continue until
about 2300utc.
I will resume tests tomorrow (Friday) night & increase power for
greater distance.
73
Gary - G4WGT
On 29 April 2010 20:18, Gary - G4WGT <[email protected]> wrote:
Hi LF,
I am increasing the PTT loop timer to provide a 5 minute increment of the
beacon.
This will give operators lots of time to create a reply or call. My
beacon will stop & notify me if a reply or call is made.
73
Gary - G4WGT.
On 29 April 2010 19:27, Gary - G4WGT <[email protected]> wrote:
Hi
LF,
I am transmitting ROS v3.4.8 data software in EME mode using the PTT
loop timer set for 1 minute.
Dial is 502.050 kHz USB
Frequency is 503.600 kHz
Tx power is 1 watt
ERP estimated at 4mW
Reports, comments & QSO attempts most welcome.
73
Gary -
G4WGT.
|
