Now also 100% copy for G0NBD (-10dB).
As Graham sends his e-mail address I activated the e-mail confirmation.
I had to switch to the SSB filter in order to decode Graham's signal, my 500Hz filter seems to narrow.
73, Rik ON7YD - OR7T
Van: owner-rsgb_lf_group@blacksheep.org [owner-rsgb_lf_group@blacksheep.org] namens Rik Strobbe [Rik.Strobbe@fys.kuleuven.be]
Verzonden: vrijdag 30 april 2010 23:23
Aan: rsgb_lf_group@blacksheep.org
Onderwerp: LF: RE: ROS test beacon 503.600kHz
Gary,
100% copy here
Signal is audible, although on the edge for CW copy.
Just below you I can see and hear a much stronger (Q5 S3) a 500Hz wide signal, but despite it's strength no decodes so far.
73, Rik ON7YD - OR7T
Van: owner-rsgb_lf_group@blacksheep.org [owner-rsgb_lf_group@blacksheep.org] namens Gary - G4WGT [g4wgt@tiscali.co.uk]
Verzonden: vrijdag 30 april 2010 22:45
Aan: LF Group (RSGB)
Onderwerp: LF: ROS test beacon 503.600kHz
Hi LF,
As before ROS data mode beacon running EME mode.
Tx frequency 503.600 kHz
Dial 502.050 kHz USB
Tx power 5 watts
ERP estimated 15 mW
5 minute increments
Report welcome.
73
Gary - G4WGT
