Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

LF: RE: ROS test beacon 503.600kHz

from [Rik Strobbe] [Permanent Link][Original]
To: "[email protected]" <[email protected]>
Subject: LF: RE: ROS test beacon 503.600kHz
From: Rik Strobbe <[email protected]>
Date: Fri, 30 Apr 2010 23:23:40 +0200
Accept-language: nl-NL, nl-BE
Acceptlanguage: nl-NL, nl-BE
In-reply-to: <[email protected]>
References: <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Thread-index: AcropogFLN/U8Sa8RUCzxFAEaKJLsQABN9N4
Thread-topic: ROS test beacon 503.600kHz
Gary,
 
100% copy here
Signal is audible, although on the edge for CW copy.
Just below you I can see and hear a much stronger (Q5 S3) a 500Hz wide signal, but despite it's strength no decodes so far.
 
73, Rik  ON7YD - OR7T
 
Van: [email protected] [[email protected]] namens Gary - G4WGT [[email protected]]
Verzonden: vrijdag 30 april 2010 22:45
Aan: LF Group (RSGB)
Onderwerp: LF: ROS test beacon 503.600kHz

Hi LF,

As before ROS data mode beacon running EME mode.

Tx frequency 503.600 kHz
Dial 502.050 kHz USB
Tx power 5 watts
ERP estimated 15 mW
5 minute increments

Report welcome.

73

Gary - G4WGT

[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  Re: LF: Re: ROS test beacon 503.600kHz, Graham
Next by Date:  LF: RE: ROS test beacon 503.600kHz, Rik Strobbe
Previous by Thread:  Re: LF: Re: ROS test beacon 503.600kHz, Graham
Next by Thread:  LF: RE: ROS test beacon 503.600kHz, Rik Strobbe
Indexes:  [Date] [Thread] [Top] [All Lists]