Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: 500 kHz WSJT JT4A

To: [email protected]
Subject: Re: LF: 500 kHz WSJT JT4A
From: Gary - G4WGT <[email protected]>
Date: Thu, 21 Jan 2010 21:45:46 +0000
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=googlemail.com; s=gamma; h=domainkey-signature:mime-version:sender:received:in-reply-to :references:date:x-google-sender-auth:message-id:subject:from:to :content-type; bh=WzCFHIPICgO9yd4asOCcIvUWcKWWlsef5G6xiN0TI50=; b=oVmkC8zDrB4xu0ucgMDjYABjxE8asByfAffCqXXZ81TXLq+rmiLYY54DgeNUPjI/sx YPl/WTlYIYcoTjHW0xk44/b+gCPJds/ZqlswkbKL63DVfeZTCOdZtT2SP2e3JN9nKURl fNB7XjM4nrlQ6wxu2wpqKJPYMQRxxq0Aoyo7o=
Domainkey-signature: a=rsa-sha1; c=nofws; d=googlemail.com; s=gamma; h=mime-version:sender:in-reply-to:references:date :x-google-sender-auth:message-id:subject:from:to:content-type; b=uB2yNHygS25Y58ibNSSVB/w8rcJpmvTZeSuvyBS+Jfpi7vqqhmHUiHw99Y58FaHpda a6hApPGhGTPgBJIfzoewOQKJBmFi9Tje1TPWDwnorchqWyplNAP98U0F63DzeVOyrFzM PV+Rd9HiECy9+/hL/5S3gc8U0+H0G7m025t0U=
Domainkey-status: good (testing)
In-reply-to: <[email protected]>
References: <[email protected]> <[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Andy,

You wrote :-
Watch & check your sampling rate calibration. for this mode.

Is that displayed in the box at the bottom left, if so then it is always within the recommended figures. I read in the user guide to watch those figures for stability & I have never seen it go outside the range specified in the manual.

There is an "Enable Diagnostics" in the setup menu but no description in the use guide (WSJT6), it must be an addition in 7.03 but not documented. Is that of any help to me?

73

Gary - G4WGT.


2010/1/21 Andy Talbot <[email protected]>
Watch & check your sampling rate calibration. for this mode.

Andy
www.g4jnt.com

This email has been scanned for damaging side-effects by the health and safety police, is guaranteed to contain no substances hazardous to health, but may contribute to dissolving the nether and polar regions


2010/1/21 Gary - G4WGT <[email protected]>
LF,

Station calling about 503.670 kHz but no decode. Not sure why :-((

Gary - G4WGT.



2010/1/21 Gary - G4WGT <[email protected]>
LF,

I am currently transmitting a WSJT JT4A test signal on 503.600 kHz at each even minute, the ERP is estimated at 200 mW.

In a while I will change the message to a CQ call & watch for any JT4A replies.

73,

Gary - G4WGT.






<Prev in Thread] Current Thread [Next in Thread>