Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: WE2XGR/2 in MFSK8

To: <[email protected]>
Subject: Re: LF: WE2XGR/2 in MFSK8
From: <[email protected]>
Date: Sat, 7 Feb 2009 17:07:02 -0500
References: <007a01c98928$ecb21240$8d01a8c0@JAYDELL> <[email protected]> <002001c9896c$d7da48d0$8d01a8c0@JAYDELL> <008e01c9896e$a7743af0$6401a8c0@asus>
Reply-to: [email protected]
Sender: [email protected]

Gary

The program keeps running okay here.

A couple other points though. Unlike Multipsk one has to specify the lower edge of the bandpass - not the middle. This is 120 Hz below the center. In other words if 800 Hz is your received audio center frequency set the frequency to 680. Maybe there is a way to set it to the center...if so I havn't found it.

The bigger problem is with other applications running at the same time. Just opened an internet browser and copy went to garbage. MultiPSK kept decoding properly.

Jay


----- Original Message ----- From: "Gary - G4WGT" <[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 4:54 PM
Subject: RE: LF: WE2XGR/2 in MFSK8


Jay, LF,

I also downloaded Stream & it runs for about 30 seconds & freezes.

73 - Gary - G4WGT.

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of
[email protected]
Sent: 07 February 2009 21:42
To: [email protected]
Subject: Re: LF: WE2XGR/2 in MFSK8

Rik and group

Confirming start at 2130Z.

Downloaded Stream earlier and was unable to get it to work. MultiPSK works
fine. May very well be
cockpit error. Will  look into it.

Jay


----- Original Message ----- From: "Rik Strobbe" <[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 4:28 PM
Subject: Re: LF: WE2XGR/2 in MFSK8


Jay,

It just downloaded / installed stream (IZ8BLY).
RX / PC is on 508.5 overnight

73, Rik  ON7YD - OR7T

Quoting [email protected]:

WE2XGR/2 will be transmitting in MFSK8 mode on 508.5 kHz from 2130Z -
0000Z tonight. Reports are appreciated.

When using MultiPSK as the decoder be advised that the program has been
known to occasionally go on 'walkabout' after loss of signal. Stopping
and restarting the decoder seems to solve the problem.

Jay  W1VD  WD2XNS  WE2XGR/2



Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm








<Prev in Thread] Current Thread [Next in Thread>