Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

RE: LF: WE2XGR/2 in MFSK8

To: <[email protected]>
Subject: RE: LF: WE2XGR/2 in MFSK8
From: "Gary - G4WGT" <[email protected]>
Date: Sat, 7 Feb 2009 21:54:30 -0000
In-reply-to: <002001c9896c$d7da48d0$8d01a8c0@JAYDELL>
References: <007a01c98928$ecb21240$8d01a8c0@JAYDELL> <[email protected]> <002001c9896c$d7da48d0$8d01a8c0@JAYDELL>
Reply-to: [email protected]
Sender: [email protected]
Thread-index: AcmJbSHnK1IU/h6dQjyFDXautaQZvwAAVQ4A
Jay, LF,

I also downloaded Stream & it runs for about 30 seconds & freezes.

73 - Gary - G4WGT.

-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of
[email protected]
Sent: 07 February 2009 21:42
To: [email protected]
Subject: Re: LF: WE2XGR/2 in MFSK8

Rik and group

Confirming start at 2130Z.

Downloaded Stream earlier and was unable to get it to work. MultiPSK works
fine. May very well be 
cockpit error. Will  look into it.

Jay


----- Original Message ----- 
From: "Rik Strobbe" <[email protected]>
To: <[email protected]>
Sent: Saturday, February 07, 2009 4:28 PM
Subject: Re: LF: WE2XGR/2 in MFSK8


> Jay,
>
> It just downloaded / installed stream (IZ8BLY).
> RX / PC is on 508.5 overnight
>
> 73, Rik  ON7YD - OR7T
>
> Quoting [email protected]:
>
>> WE2XGR/2 will be transmitting in MFSK8 mode on 508.5 kHz from 2130Z -
>> 0000Z tonight. Reports are appreciated.
>>
>> When using MultiPSK as the decoder be advised that the program has been
>> known to occasionally go on 'walkabout' after loss of signal. Stopping
>> and restarting the decoder seems to solve the problem.
>>
>> Jay  W1VD  WD2XNS  WE2XGR/2
>
>
>
> Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
>
> 




<Prev in Thread] Current Thread [Next in Thread>