Hi Wolf,
Thanks for the info, I set the refresh interval to 30 secs & it takes 28
secs to complete the page then it starts to refresh the page almost
immediately not giving time to study the page, so I have set it now for 60
secs & I have 30 secs to study the image before next refresh.
My broadband is supposed to be up to 8Mb & shows connection speed 7.7Mb but
up & down loads are much slower than that.
Cheers,
Gary - G4WGT
----- Original Message -----
From: "Wolfgang Büscher" <[email protected]>
To: <[email protected]>
Sent: Friday, January 04, 2008 11:37 AM
Subject: Re: LF: Re: Re: GM4ISM 500KHz Grabber
Hi Gary,
You wrote:
Only small strip at top of screen, the slow link is ok.
Increase the value of the "Refresh Interval" from 2.0 to 30 seconds (on
the bottom of the screen).
I have Mark's grabber running for about an hour now, and at that update
rate, there was not a single error.
There is a strange signal nead 504 kHz now, drifting in frequency, which
must be local. It goes on and off every few minutes.
73,
Wolf .
|