Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: RE: Re: Re: [Lowfer] RE: litz wire

To: [email protected]
Subject: LF: RE: Re: Re: [Lowfer] RE: litz wire
From: "Ashlock,William" <[email protected]>
Date: Fri, 17 May 2002 15:39:38 -0400
Reply-to: [email protected]
Sender: <[email protected]>
Mal,

I have wound a loading coil using decca 729 strands litz and another 2.5mm
teflon insulated wire one and compared results. On air measurements and
reports are identical, regardless of what theory dictates.

Am I going to have to send you a loading coil made from #12 copper and and
another with identical dimentions from #12 Litz to prove to you there is a
2x reduction in Rac? Assume you have a way to make these measurements? Using
on-air measurements as a way to measure a change less than 3db is not a
sound approach, especially if the A/B change can't be accomplished by simply
flipping a switch. This change in fact could be under 2db due to the
additional series resistance in the circuit added by soil loss.
Regards,
Bill A
_____________________________________________________________________
This message has been checked for all known viruses by UUNET delivered through the MessageLabs Virus Control Centre. For further information visit
http://www.uk.uu.net/products/security/virus/



<Prev in Thread] Current Thread [Next in Thread>