John Sexton wrote:
Hi Argo users,
While using Argo to receive 10 second dot QRSS transmissions, I selected 10
second dot mode, but found that everything blurred together, and it was
virtually impossible to read it.
When I changed the setting to 3 second dot mode, everything became clear and
well separated. The dots could clearly be seen to be 10 seconds long.
Is this normal? or am I doing something wrong?
John, G4CNN
Hello John,
this is not quite normal. You should see no blurring, or at least a moderate
blurring
but not so high to make the signal unreadable.
Are you perhaps using too much sensitivity and/or contrast ?
Try to set these two adjustment to the minimum setting that still allows you to
see the signal,
and adjust the input level so that the green vertical level bar stays in the
lower half.
Hope this helps
73 Alberto I2PHD
|
