Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]
<prev [Date] next>
[Advanced]
 <prev [Thread] next>

LF: Tip

from [gii3kev] [Permanent Link][Original]
To: "rsgb rsgb" <[email protected]>
Subject: LF: Tip
From: "gii3kev" <[email protected]>
Date: Wed, 12 Sep 2001 09:22:44 +0100
Importance: Normal
Organization: Netscape Online member
Reply-to: [email protected]
Sender: <[email protected]> 
Hi All
Litz wire.

To solder litz wire of the variety used by Decca.
Strip off about 10 -20 mm of the plastic/cotton covering
Dip the exposed end in paint stripper for a few minutes.
Use a tooth brush to remove the disolved enamel insulation, dip end in
white spirit and wipe.
Solder the exposed bare copper end in the usual way.
Using this method no special tools or solder pots are required.
This procedure is not required for the self fluxing litz type wire.
G3KEV
[More with this subject...]
<Prev in Thread] Current Thread [Next in Thread>
Previous by Date:  LF: OH1TN Reino active again at 2155z (Tues), Alan Melia
Next by Date:  Re: LF: OH1TN Reino active again at 2155z (Tues), gii3kev
Previous by Thread:  LF: OH1TN Reino active again at 2155z (Tues), Alan Melia
Next by Thread:  LF: RE: Tip, Michael Probert
Indexes:  [Date] [Thread] [Top] [All Lists]