Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Antenna maintenance; Denso; and Leicester

To: "LF Group" <[email protected]>
Subject: LF: Antenna maintenance; Denso; and Leicester
From: "Steve Rawlings" <[email protected]>
Date: Mon, 17 Sep 2001 18:05:12 +0100
Reply-to: [email protected]
Sender: <[email protected]>
Hi All,

I've been off the air recently while I carried out routine maintenance to
my
LF antenna (now completed).

This work included removing; repainting; and re-installing the T and K
brackets
on the back wall.  Once again, I have water-proofed the exposed parts of
the wall fixings (Rawlbolts) and the threaded parts of the 'U' bolts, using pieces of synthetic rag coated in thick motor grease. It's a messy job, but, when I need to repeat the maintenance tasks, at least I'll be able to release the wall fixings again!

[[ TIP: For the heads of Rawlbolts, I trap two layers of greased synthetic rag (about 50 mm x 80 mm) between the bracket and the washer. Then I tighten the bolt, put more grease on the bolt head, and then carefully fold the rag over the bolt head - a corner at a time - to form a firm 'bandage' over the bolt.

Where the external fixing is a nut (in cases where the threaded part of the Rawlbolt is held captive in the wall), I first tighten the nut. I then tear strips of synthetic rag (about 15 mm wide), coating the strips in motor grease. After putting grease on the nut, and threaded stud, I then wind two or three of the coated strips around the nut, and around any exposed studding, until they are fully covered in the sticky bandage.

John G3CCH reminds me that there used to be a product called Denso
(spelling? but pronounced 'den-zo') which would probably have done the job better. But my poor man's Denso tape seems to work well enough.]]

The 2-inch mast is now topped with a second-hand fibreglass wind-surfer
pole (about 4 m long), which replaces a previous aluminium section. The wind-surfer pole was purchased for 20 pounds, and I have painted it to reduce possible damage by ultra-violet radiation. The first station heard after putting my antenna back up was G3CCH, who has also been busy with antenna maintenance jobs. His recent work seems to have paid off, as John's 136 kHz signal is certainly stronger here in Chepstow. If you've been putting off those outside antenna maintenance chores, it's probably time to make a start before those gale-force winds start up again!

By the way, Vic G8IK and I will be at the Leicester show for a few hours on the Saturday.

Regards to all,
Steve GW4ALG


<Prev in Thread] Current Thread [Next in Thread>
  • LF: Antenna maintenance; Denso; and Leicester, Steve Rawlings <=