Hello John.

09.27
switch on IC756, rx converter, and connect to 1m indoor loop. Turn to NE
(ish)
switch on signal generator and frequency counter and adjust to 71.85kHz
look at spectrogram. Set  dwell to 400ms 5.5k samples 16k resolution. Look to
find "calibration trace" adjust filtering on rx to suit.

09.38  Switch off sig gen.
Hey presto........instant slow CW within a couple of Hertz. Good signal about
10dB above noise. Partially audible in speaker when using DSP 80Hz filter.

Try to decode CW but a little puzzled about dot speed. Seems shorter than 10
seconds. Difficult to read message as it appears to be more than a callsign
and takes several screens before it repeats.  Recheck calibration.   Yes 71.85
+/- 2Hz.

10.00  Signal pauses. and then arggggh  local noise appears and that's that.

10.50  Local noise goes off.   Check calibration, see signal spot on 71.850.
Read CW     G   0  (hit record button) A  K  N.       Perfect signal   O
report.
Dot length apx. 4 seconds

Large .wav file in log.  Never did peak the loop on Oxfordshire.

Should have plenty of reports with that signal.   Well Done.

73

David    G0MRF  IO91TK