Hi Ken, OK, but if you have no problems with the current filter, you will have no problems on 472 as well. So it might be sufficient just to readjust it to the new band next year. Anyway, the mechani
Stefan. Thank you for the info, maybe sometime you will be able to post the circuit? 73. Ken M0KHW Ah yes, Thomas was faster, damn ;-) Another image from the experimental setup, using source follower
Hi Ken, OK but later. I want to try some modifications, i.e. using the 500 Ohm input and the 18 kOhm output, to have some gain. If this does not affect the matching, i would prefer that... 73, Stefan
Hi Stefan. Fully understand. 73. Ken. M0KHW Hi Ken, OK but later. I want to try some modifications, i.e. using the 500 Ohm input and the 18 kOhm output, to have some gain. If this does not affect the
Hi Stefan. Thank you for all the filter info, definitely interested in them, at present for 500kHz I have a homebrew filter using two Toko transformers in between the antenna socket and two stage rx
Hi Stefan. I have resent this reply, I think the original with an attachment may have been blocked The answers to your questions are. My RX is a Kenwood TS140S. Antenna, 102ft doublet centre fed with
Ah yes, Thomas was faster, damn ;-) Another image from the experimental setup, using source followers https://dl.dropbox.com/u/19882028/MF/Mechanical_filter_with_source-followers.JPG The results have
Hy Ken, the name of the mechanical filter is FZ02 http://www.oppermann-electronic.de/html/hf-spezialbauteile.html http://dm4tr.bplaced.net/index.php?section=Receiver 73 Thomas DM4TR Hi Stefan. What m
Hi Ken, My thoughts, Am 16.09.2012 22:07, schrieb Ken: Hi Stefan. Thank you for all the filter info, definitely interested in them, at present for 500kHz I have a homebrew filter using two Toko trans
PS: You know, you can use the input stage directly as an active E field antenna which is for MF only. You would prevent the overload of a poor RX by MF AM BCD stations... 73, Stefan Am 15.09.2012 02:
Hi Stefan. I should have said was there to remove any BC overload which it does vey well Ken M0KHW Hi Ken, I just tried to use the 500 Ohm input and the 18k Ohm output. It works UFB but then i got wo
Hi Ken, I just tried to use the 500 Ohm input and the 18k Ohm output. It works UFB but then i got worried about destroying the filter due to the up-transformation on the input (the max. input voltage