Hello James and the group! Thanks for the reply. Unfortunately I can't copy your signal in the moment, let's hope for the evening/night. I'm using my shortwave-antenna, a 55m long endfed wire in abou
Hello Group! @James: Thanks a lot. Built a L-filter and the sensitivity is now at least 10db (maybe even more) better. -60dbm (instead of -50dbm) fed into the same wire than before can now be seen cl
Dear Gerhard, LF Group, I am currently (1242utc) transmitting a DFCW beacon signal on 137.680kHz, with ERP of about 300mW. There is some QRN here, but band noise is not too bad. QTH is just north of
Hello Jim , James Moritz a écrit : Any reports very welcome, Your signal is virtually identical to this after midday , the ratio sign / noise is around : 22 dB . I cannot give absolute value because
Dear Gerhard, LF Group, Sorry you have had no luck so far - I'm sure improvements will be possible. I will leave the beacon running a little longer - I have QSY'ed to 137.690kHz so you can see how th
Hi James, Hello group! Thanks a lot for your efforts, but still no copy here. I watched out for the beacon until now but I have a lot of QRN/M. Something is basically wrong with my RX-design and I ha
Dear Jim, yes you were about 3 to 4 µV/m here last night - quite a good signal which would have certainly been audible if not for the statics. The appended clip shows four of your sequence repetition
Dear Gerhard, LF Group, The beacon is now running again at 2000utc, as before in DFCW mode centered on 137.680kHz. I will leave it running for a few hours at least. It is still quite light here, so I
Hello Gerhard, OE5ODL can put out a respectable signal whenever you want. I can help set up a sked, if you reply to my email adress (just google my callsign). 73 Heinz, OE5EEP Gerhard Hickl schrieb:
Dear Gerhard, Nicolas, Jean-Pierre, Thanks for the reports - the beacon is now QRT at 1530utc. I will try again later when it begins to get dark at around 2000utc for a few hours - I expect signal le
Jim, audible copy here on the 500kHz antenna 73, Rik ON7YD - OR7T Dear Gerhard, LF Group, The beacon is now running again at 2000utc, as before in DFCW mode centered on 137.680kHz. I will leave it ru
Dear Markus, LF Group, Thanks for the screen shot from Sunday night The appended clip shows four of your sequence repetitions, as seen in a high resolution 21 mHz FFT - of course not readable but sti