Thanks, i'll keep going on op4 for the whole night than. But we all should try to test op8 than probably tomorrow night? 73, Jochen -= DF1VB =- -= KH2MM=- Jochen Althoff +491712001068 [email protected]
Hi all, i will be transmitting OP4 at 477khz dial all 8 Minutes for a while, and of course rxing.... At request i am also able to qsx in the 501khz segment. 73, Jochen df1vb -- -= DF1VB =- -= KH2MM =
No, i am using a juma-500 tx and a com port interface at the keying input of the tx. Jochen Am 09.11.2012 18:55, schrieb Graham: Yes , but no decode since 16:36 477 DF1VB Op4 -29 dB .... at the momen
Well, i can't turn down my tx more... 4w is lowest possible. Now back to 65w... Jochen -= DF1VB =- -= KH2MM=- Jochen Althoff +491712001068 [email protected] Am 09.11.2012 um 20:58 schrieb Graham: 19:56
Graham, what do you think, shall i switch to OP8 now? Is't it so that the Programm is switching the rx automatically? The OP4 / OP8 switch has only affect for the TX, or? 73, Jochen -= DF1VB =- -= KH
Hi Graham, I think Jochen was back up at 65W at the time of the decode. https://dl.dropbox.com/u/26404526/mf_1211092000.jpg Best of luck, Markus (DF6NM) From: Graham Sent: Friday, November 09, 2012 8
Graham, Jochen, well that's not too bad then! Sorry for my mistake, the 4 Watt transmission 19:52 to 19:56 looked quite strong on my grabber in Nuernberg as well. As I sometimes get large delays on b
No, the power description was modifyed just in time and reflects my tx output. The 19:56 sequence was at 4w tx out.... 73, Jochen -= DF1VB =- -= KH2MM=- Jochen Althoff +491712001068 [email protected] A
OK, I thought possible you where under the carrier (less than +/- 2.5 Hz ) , but now decoding ok , must of been a dip in signal as noise floor , my be ok with 10 watts ? 73 -G.. 19:18 477 DF1VB Op4 -
At-25 with Mal , that was with 4 watts , shows at the end of the text , -11 dB is back with 65 watts 20:46 477 DF1VB de G3KEV Op4 388 mi -11 dB in SCARBOROUGH with 65w + Inverted L RX3DHR is monitori
So far so good ! Just going dark at Liverpool 73-G. 16:36 477 DF1VB de PA0A Op4 132 mi -17 dB in Lucaswolde with 65w + Inverted L 12 16:36 477 DF1VB de PA3BHT Op4 135 mi -20 dB in DELFZYL with 65w +
Hi Graham, thanks for the report. It looks that my tiny antenna is somehow radiating ;-) 73, Jochen Am 09.11.2012 17:39, schrieb Graham: So far so good ! Just going dark at Liverpool 73-G. 16:36 477
19:56 477 DF1VB de G3KEV Op4 388 mi -25 dB in SCARBOROUGH with 4w + Inverted L 1 well 6 dB 1 watt should decode Smile emoticon Smile emoticon From: [email protected] Jochen Althoff Sent: Friday, Novemb
NO Don't switch !!!!! The Rx stations will need to select OP8 , and many will be unattended and will not decode ( the early versions where dual rx/speed but produced too many false decodes , so separ
Yes , but no decode since 16:36 477 DF1VB Op4 -29 dB .... at the moment I can see a very small trace ... are you using the audio drive via transverter ? I have a carrier (may be internal) at the low
Still 2 dB left hi , but better qro as many stations are now on frequency ! 19:43 477 DF1VB Op4 -29 dB 19:31 477 DF1VB Op4 -25 dB From: Jochen Althoff Sent: Friday, November 09, 2012 7:38 PM To: rsgb
One more try with 4w now ;-) -= DF1VB =- -= KH2MM=- Jochen Althoff +491712001068 [email protected] Am 09.11.2012 um 20:46 schrieb Graham: Still 2 dB left hi , but better qro as many stations are now on