NO Don't switch !!!!!
The Rx stations will need to
select OP8 , and many will be
unattended and will not decode ( the early
versions where dual rx/speed but
produced too many false decodes , so
separate pass bands are defined)
Better to post in the web
group's before , then monitors will
be set OP8
It is possible to run X2 opera
one set op4 and the other op8 for
Rx
Tx , if using the audio o/p , then the
frequency is changed to the other pass
band ( if you have rx / tx by
convertor / sdr , the tx carrier is placed a
the lowest s/n point in the spectrum , to
prevent collisions)
G..
Sent: Friday, November 09, 2012 9:19 PM
Subject: Re: LF: MF: OP4 at 477 dial all 8 Minutes
Graham,
what do you think, shall i switch to OP8 now? Is't it so that the Programm
is switching the rx automatically?
The OP4 / OP8 switch has only affect for the TX, or?
73, Jochen
Am 09.11.2012 um 22:11 schrieb Graham:
At-25 with Mal , that was with 4
watts , shows at the end of the text ,
-11 dB is back with 65 watts
20:46 477 DF1VB de G3KEV Op4 388 mi -11 dB in SCARBOROUGH with 65w + Inverted L
RX3DHR is monitoring so you never know
, may decode later in the night ...
OP8 has never been tested on 500 at any range
, may be that's something that could
be tried one night .. ?
73 -G..
Sent: Friday, November 09, 2012 8:57 PM
Subject: Re: LF: MF: OP4 at 477 dial all 8
Minutes
Hi Graham, I think Jochen was back up at 65W at
the time of the decode.
Best of luck,
Markus (DF6NM)
Sent: Friday, November 09, 2012 8:58 PM
Subject: Re: LF: MF: OP4 at 477 dial all 8
Minutes
19:56 477 DF1VB de G3KEV Op4 388 mi -25 dB in SCARBOROUGH
with 4w + Inverted L 1
well 6 dB 1 watt should
decode <Emoticon1.gif>
Sent: Friday, November 09, 2012 9:03 PM
Subject: Re: LF: MF: OP4 at 477 dial all 8 Minutes
Well,
i can't turn down my tx more... 4w is lowest possible.
Now back to 65w...
Jochen
Sent: Friday, November 09, 2012 7:53 PM
Subject: Re: LF: MF: OP4 at 477 dial all 8
Minutes
One more try with 4w now ;-)
