Dual Beacon test wspr & OP4 . TX only due to overlapping , Carrier 20 watts per mode WSPR = 100% Tx OP = 1 min timer Running now 1645 z TX set 500 KHz USB Rx set 500Khz USB , run WSPR and Opera as no
May be 100/200 mW per mode at the moment , Gary -15 dB at 33Kmtr range 2012-02-12 20:38 G0NBD 0.501498 -15 0 IO83lk 0.01 G4WGT IO83qo 33 56 From: [email protected] Graham Sent: Sunday, February
Dear Graham, LF Group, Both signals decoding 100% last time I looked. Bear in mind that QSB is causing 20dB or more of variation within a single transmission period at the moment, making each transmi
Just added OP8 at 23-15 z for the last hour Dear Graham, LF Group, Both signals decoding 100% last time I looked. Bear in mind that QSB is causing 20dB or more of variation within a single transmissi
Graham I have been monitoring your Opera and WSPR sigs since 1800. Wellbrook Loop + SDR-IQ with VAC to the dual decoders. The Loop was positioned with North/South nulls until 23:05 (you are 13 deg E
Having a problem stopping the decodes , now have 25 dB atten in the Tx drive path, power meter is not moving more than the needle width ... still showing with PA0A , Dear Graham, LF Group, Both signa
1 or 2 watts feed to the Ae per mode at the moment , decodes showing -26 dB which is starting to be under the noise ? From: [email protected] mal hamilton Sent: Sunday, February 12, 2012 6:35 PM
Dear Mal, LF Group, ...>You are the only one that I can decode. There is a serious problem somewhere...> The other stations are decoding normally here and elsewhere, so the problem seems to be at you
Thanks Terry Forgot to add the OP8 mode ! .. now running since 2315z 73 -g. Graham I have been monitoring your Opera and WSPR sigs since 1800. Wellbrook Loop + SDR-IQ with VAC to the dual decoders. T
Yes V1.2.8 but if I can decode one stn then there cannot be a problem here. You lot are all in each others back yard, when it comes to distance then there seems to be a problem which I think is, TX p
Added OP8 at 2315z for the last hour , power still round 100 / 200 mW per mode , all modes are equal power level. From: [email protected] Graham Sent: Sunday, February 12, 2012 8:44 PM To: rsgb
Graham es CO You are the only one that I can decode. There is a serious problem somewhere because I can copy the USA on normal CW on 500 during night time. Are all the UK stns QRPP or what ?? Seems s
Power down to round 3 / 4 watts showing on meter with 2 tones , difficult to measure with the set up at the moment , just checked the carrier balance with 2 tones and both peaks on the same line on s