Stefan LF Today, early morning was so quiet on VLF that I thought that my ELF SpecLab RX I was running yesterday was playing up, I started a second RX with a faster sample rate, which is on my Grabbe
Seems anything from bplaced dot net is now on the balck list at blacksheep dot org Hence it took 2hours to get my last NOW message displayed, is it time to go back to post cards.:-) Test for my Grabb
FB Henny A capture from me this morning. 73 Eddie G3ZJO On 28/05/2011 11:23, henny van elst wrote: Hello LF, Capture Zevs this morning 08:00 Utc Henny pa3cpm 73's Het bericht kan nu met het volgende
Sorry Daniele no idea 1.7Hz and multiples. Both Stefan and I have an 80Hz constant carrier, I am also pretty sure about 16Hz 32Hz and 64Hz being received signals. Perhaps the growing band of listener
Interesting, 11.7Hz is barely visible here today. I shall take some computer fans outside and run them on 12 Volts near my E-probe. Eddie On 09/05/2011 10:36, Daniele Tincani wrote: I have found that
Hi Daniele / Chris et al I will take a good look at the ZEVS breakfast code in moment, I have a burst of noise covering the start bit. OK on the 11.7Hz Daniele, I will take a close look there too to
Thanks Jean-Louis There is so much information on www.vlf.it, I seem to remember seeing your information a week or two ago, when I was first looking at ELF. 73 Eddie Please get a look on http://www.v
Hi Henny Nice, (or no so nice), to see the noise. Do you know the source of the equally spaced lines which start at greater amplitude. I assume it is mains related, I have similar lines visible now,
OK Roger If you TX'd at 1408 then i can see your signal but its very weak. Eddie On 21/05/2011 14:25, Roger Lapthorn wrote: Just started 137.5kHz WSPRing at 1325z Saturday. Hope you see me Eddie. 73s
Stefan ZEVS is on now. Eddie On 05/05/2011 17:05, Stefan Schäfer wrote: Hi Eddie, Daniele, ELF ;-) My temporarely window is running here http://www.iup.uni-heidelberg.de/schaefer_vlf/DK7FC_VLF_G
Thanks for the rescue Pete I have very little experience with Winrad. Ken uses it and understandably wanted to try with what he knows, he has Speclab and a config fie for 8.97kHz. Sounds like time fo
Hi Henny Do you see shifts other than these. 80.8 = Tone 01 - Space 81.0 = Tone 02 81.2 = Tone 03 81.4 = Tone 04 81.6 = Tone 05 81.8 = Tone 06 82.0 = Tone 07 - Idle 82.2 = Tone 08 82.4 = Tone 09 82.6
Hi Daniele I will send them to you direct plus a full screen shot also. 73 Eddie On 05/05/2011 14:30, Daniele Tincani wrote: Hello VLF, could some of you be so kind to re-send the two Eddie's JPEG's
Hello Stefan I was prompted to take a look 'down low' a couple of weeks ago when SM5LE said, look 'Schumann resonances'. You will be surprised that I am using your E-Probe, unmodified. I wasn't expec
Just a little more information on the way I am reading ZEVS G3WCD and me are 'singing from the same hymn sheet' There appear to be 12 tones. 7 is Idle or Start tone 1 is Repeat or Space tone A Breakf
LF The noise on 8.9kHz is beginning to rise now, there are multiple lightning strikes across Europe. G3XIZ has vanished in my DFCW600, broken in DFCW3000, but still 10dB above the noise in DFCW6000.
Hi Roger You have re-started, the only way I know to cure it. I once asked Stefan, knowing that you also know how to stop Spectrumlab outputting anything like me:- "What am I, a novice moron doing wr
QSL from my Grabber http://g3zjo.bplaced.net the breakfast transmission today 324 324 73 Eddie G3ZJO On 26/05/2011 10:52, henny van elst wrote: Hi LF, Capture Zevs,08:00 Utc this morning, Henny pa3cp
Hi Henny I noticed this yesterday, I don't recall the time, QRN caused a little difficulty with reading the data but the shift was odd. I am not looking today, I was going to use that computer for an
Thanks Wolf Did you ever put numbers to the data units? 080905.jpg is familiar to us as a breakfast or tea time 3 unit code, reading 6,11,12 0080906jpg is more complex 3,8,6 - 6,8 -- 9,11,10 - 12,4 T
