Just completed another QSO with Finbar. This one lasted about 15 minutes and call signs, two sets of signal reports (to report changing conditions), outdoor temperatures and other bits of information
A short write-up on modifications and test results of the Hafler 9505 as a linear amplifier at 500 kHz... http://www.w1vd.com/9505MF.html Jay W1VD WD2XNS WE2XGR/2
Brian Reception continued through the night at a similar level to the earler capture...with the usual periods of fading and no copy. Fade out was at 0300Z. What is the new antenna and power level? Ja
Jim Thanks for the very informative investigation. So...if you make accurate FS measurements and accurately characterise your antenna system (and document it for the authorities!) can one can just ad
One additional note...if you close the program and restart it you'll have to double click on the waterfall again. Apparently the program does not remember the previous run settings... Jay W1VD WD2XNS
Just fired up XGR/2 on 506.5 Jay Jose At 2358 utc sig peaked and got full callsign. Wonder if any other USA stns on at present on 500 mal/g3kev OK Mal, Typical QSB of this band observed here as well.
12/24/07 Good reception of SAQ this morning. Signals were at their best during the pre-session tuneup, unfortunately IDs were few and far between. A clip of the pre-session with alternator coming up
T/A enthusiasts WE2XGR/2 506.5 kHz cw beacon on at 2200Z . Reports from EU would be appreciated. Beacon will be operational until at least 0030Z. Jay W1VD WD2XNS WE2XGR/2
Brian Signals not as consistent as the night before with significantly more fading. Best capture of the night below. Jay W1VD WD2XNS WE2XGR/2 Attachment: CT1DRP120507.jpg Description: JPEG image
Mal Neither the XSH or XGR 500 kHz stations are licensed to work amateur radio operators crossband at present. Perhaps you could pass this along to Jack and other interested parties. Tnx. Jay -- Orig
T/A enthusiasts GI4DPE / WE2XGR/2 completed QSO #3 earlier this evening. Finbar had excellent copy throughout although reported rapid and very deep QSB. Copy at XGR/2 was somewhat more difficult with
Mike Looked several times last night but no joy. Jay W1VD WD2XNS WE2XGR/2 I have at last got a system reliable enough (fingers crossed) to run an overnight DX beacon. I will run QRSS60, starting at e
Laurie I've been using the RF-590 for 8 years now as my primary LF/MF receiver with no problems or complaints. The 1 dB compression and 3rd distortion is on par with other 'premium' military grade re
