Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: QRSS activity this weekend

To: <rsgb[email protected]>
Subject: LF: Re: QRSS activity this weekend
From: "F6CNI - Andy - JN19QB" <[email protected]>
Date: Sat, 15 Jul 2017 15:46:11 +0200
Importance: Normal
In-reply-to: <[email protected]om>
References: <[email protected]> <[email protected]> <[email protected]om>
Reply-to: [email protected]
Sender: [email protected]
Same here using a TCXO. I think my QRG accuracy is about + / - 0.1 Hz on LF also. HI !
 
Sent: Saturday, July 15, 2017 3:38 PM
Subject: Re: LF: Re: QRSS activity this weekend
 
Near enough.  Its only a TCXO controlling the frequency, so a ppm or two of error can be expected
 
Andy
 
 
On 15 July 2017 at 14:32, F6CNI - Andy - JN19QB <[email protected]> wrote:
 
Hello Andy G4JNT
 
Good copy. Your SlowCW-30 is on 136173.99 Hz now. Is that correct ?
 
Andy de Andy F6CNI...
 
Sent: Saturday, July 15, 2017 3:08 PM
Subject: Re: LF: QRSS activity this weekend
 
Hi Andy,

just shifted my Eu-grabber a few Hz up, and Bingo there's your fine signal. Albeit a bit clobbered up by my local transmissions on 137705 Hz.

If you went a few Hz down to below 136175 Hz you'd surely be picked up by several European grabbers (e.g. DK7FC).

Best 73,
Markus (DF6NM)

http://www.df6nm.de/grabber/Grabber.htm



-----Ursprüngliche Mitteilung-----
Von: Andy Talbot <[email protected]>
An: rsgb_lf_group <[email protected]>
Cc: rsgb_lf_group <[email protected]uk>
Verschickt: Sa, 15. Jul 2017 14:58
Betreff: Re: LF: QRSS activity this weekend

Having just put the 137kHz system back together, cobbled together an on-off modulator and reprogrammed a beacon keyer module for QRSS...
I [think]  there's a SlowCW-30  signal going out on 136.179kHz,  which is a few Hz above where Mike said he'd be running in the evening.
 
Its so long since I've done this on-off stuff hope I've chosen a suitable frequency.  It can be shifted at a moments notice if requested.
 
Andy  G4JNT
 
 
<Prev in Thread] Current Thread [Next in Thread>