Return to KLUBNL.PL main page

[Top] [All Lists]

Re: LF: RE: Combining LF amps revisited

To: Clemens Paul <[email protected]>
Subject: Re: LF: RE: Combining LF amps revisited
From: Chris Wilson <[email protected]>
Date: Mon, 15 May 2017 11:59:15 +0100
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed;; s=20161025; h=from:date:message-id:to:subject:in-reply-to:references:mime-version :content-transfer-encoding; bh=qtAPJXMYohC6cpQKXENotahIbKdDsnG+MHBH5QeXShY=; b=DIKYeq1bcOfsWGu9fuIup1sJVWnCS4B3AI8WlJ3Upj4E7rW0hLNlp8dmCAiQiitmVn vM5kYBJGtASc1eljbxtsC2RP0lrK3/ng5fsn3i/0+YK2k95jb9oQ2zaHC95/aWmDGKDq ifHpUG4IvaZunWscD8inKPNpSGTigQfmHbdwZOrnxDpyMj9ZrdBZSzf5WpjvVZAy3LpB wd+5k1J5euKz6bLhpc3B+U6WYacDVWU96tLFrDfmguWys2kgNTmbBfUlmXOPCzaak6MW itGATeO/BnNHX1C+YqmdDCq/tNPOTWLDYNLklGw7YndAbC/DqhwMQPPKatZ5dhxZfAgg jFUQ==
In-reply-to: <[email protected]>
References: <[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Hello Clemens,

Thanks  for  the  reply, the 3 stacked cores will rise to 70 degrees C
plus  even with a small computer processor fan blowing through them. I
am  investigating  ways  of  reducing  this, the cores are shown as 77
material  in  jay's  schematic,  but  he  and I are using the newer 78
material  for the PA output transformer cores. I may try using this 76
material  in  the  combiner transformer. Someone else suggested making
the   PA   output   transformers   work   at  100  ohms  and  using  a
transformer less  zero  degree  hybrid  coupler.  I'd  try  Andy's twin
primary,  one  secondary  transformer instead of the coupler if i knew
what winding ratio and what core to start off with. Thanks again.

> Hi Chris,

> I have a tool by DJ5IL here which predicts around 60°C for the cores
> (excluding heat caused by the winding)
> and ca. 480 Gauss flux density.

> 73
> Clemens
> DL4RAJ  

Best regards,
 Chris                            mailto:[email protected]

<Prev in Thread] Current Thread [Next in Thread>