Unless the LPF is part of the tuning ?
--------------------------------------------------
From: "DK7FC" <[email protected]>
Sent: Friday, April 21, 2017 7:55 PM
To: <[email protected]>
Subject: Re: LF: Dummy load testing without LPF?
Hi Chris,
Without the LPF, it is even less critical because there is a pure
resistive load for the whole output spectrum.
So just do it...
73 from JN49KL09AB
Stefan
Am 21.04.2017 20:10, schrieb Chris Wilson:
Hello LF'ers,
Push pull output, Class D low frequency (136kHz) RF amp, circa 500
Watts. If I want to test it for a few hours into a dummy load does it
matter if the low pass filter network usually used is not between the
output transformer and the dummy load? I want to leave it running
overnight and I am modding the LPF and it's in bits until next week.
Thanks.
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
|
