Hello
Stefan,
isn't
Ossy at 8790,3?? If so it should be no problem.Henny's vfo is a Adret (pll)
signalgenerater adjustable in 0,1 Hz steps.Time base is a ocxo,I just see a
drift of a few mHz during the day,but this could also be my own ocxo for the rx
or the soundcard....
73
Victor
Hello Victor,
Oh, then it becomes
uncertain: Ossi is transmitting on about the same frequency. I know about
Ossis strength here and assume Henny is weaker. But just wait if one will see
two lines close to each other at all. We can check the ID question
later...
What is the VFO? A DDS?
73, Stefan
Am 20.02.2011
16:37, schrieb [email protected]:
Hello Stefan,
I
measured his freq as 8970.025 Hz. Not an absolute number but a good
guserment:I checked 60.000 KHz to be at my zero line and then I tuned to
8970Hz .Henny comes ub 25 mHz above the zeroline,
73 GL
Victor
Hello Henny,
Nil so far. If
you can transmit at 8970.0000 for at least 10 hours i could see something
in my 60000 window, for a first step.
73, GL es
fun,
Stefan/DK7FC
Am 20.02.2011 09:30, schrieb henny van
elst:
gm LF,
Again QRV with a small signal on
8.970 Khz,
henny
pa3cpm
|
|