Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: VLF - G3XIZ transmitting today

To: [email protected]
Subject: Re: LF: VLF - G3XIZ transmitting today
From: Andy Talbot <[email protected]>
Date: Fri, 31 Dec 2010 09:39:19 +0000
Dkim-signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=gmail.com; s=gamma; h=domainkey-signature:mime-version:received:received:in-reply-to :references:date:message-id:subject:from:to:content-type; bh=vs08psPvkDHubw6+TQpFD40J9I8gWbn5PA2l8cREEmg=; b=q9IbEc12aXF/RhnNStP/kkxx+ONF4pqMagIvk5oQWcD1Zaq15iDfy/4G3plRNY9G0G WqTS40Mk5TDjOsEwFZqY7imU0LzSKi9ue6RGMySIHiHmIvT6rDFh1GFzzuwYvakBmZa2 1OGM0e55a2pGkJdGuMJoK3h4sdzlAuj6nMAsg=
Domainkey-signature: a=rsa-sha1; c=nofws; d=gmail.com; s=gamma; h=mime-version:in-reply-to:references:date:message-id:subject:from:to :content-type; b=YXMHVbAGri26lzJU52D8PxrTT0UCoe+vYx+vulu+PTYqzyv1bZsZb9nE+qL3CDQMrm kGub9uVaEF15ZID+3Z2x/8bvdzwALXej2+hR1S+bFGbupFeLNCpvoXJt8oYm+pw4lI2I psqlli3u+UKd/owpD/BvZhm+bk+ufMca6nNIk=
Domainkey-status: good (testing)
In-reply-to: <[email protected]>
References: <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
SDR-IQ is running, with a 20Hz wide waterfall looking in 0.03Hz FFT bin size.
It took 5 minutes for a calibration signal to show up on the screen.
The paint is drying - slowly :-)0
 
If you want to send QRSS identifier at high speeds (relative) , suggest you repeat at 10 or 15 minute regular intervals.  They will then show up up as periodic reductions in carrier level of about 3dB or so.
 
If fact, tht just may be a suitable task for a new bit of software or a PIC - a mixed QRSSSSSS generator
 
 
Andy


 
On 31 December 2010 08:44, Chris Osborn <[email protected]> wrote:
LF,

I shall be transmitting VLF today starting at 09.00 Z

Freq:    8.971 855 kHz (nominal but close)
Mode : Continuous carrier with occasional QRSS identifier
Aerial:  Initially:  40m inverted 'L' at 10m 
           Later:     balloon supported aerial at 50m

Hopefully the system will keep going as the loading coil re-wind
seems to have done the trick now that the varnish has dried.

73
Chris
G3XIZ


<Prev in Thread] Current Thread [Next in Thread>