|
----- Original Message -----
Sent: Tuesday, July 20, 2010 6:58 PM
Subject: Re: earth antenna
Stefan
Keep climbing until you get enough height for an
airborne Antenna., try a 300metre tree in the black forest, I might hear you
then
g3kev
----- Original Message -----
Sent: Tuesday, July 20, 2010 6:50
PM
Subject: VLF: earth antenna
Dear VLF,
Today i was in the forest for more than 10
hours doing the following tests/works :-) :
Today i did my test on
8,97 and 7,97 and 6,97 kHz. It was possible to transmit on the lower
frequencies like one can still see on my grabber2. The antenna current was
just about 220 mA and 130mA in the 8,97 test. There were some problems with a
step up transformer in combination with the big PA, thus the low current (i
used a 12V/150V DC/DC converter and batteries, not my generator for high
power). So the signal was even 3 dB lower than in the "73" test on 8,97 before
some weeks. On 8,97 the power was 8 dB lower, thus there was no reception on
8,97 today but as we know, it works best on 8,97 in 5km distance. The lower
the frequency the more i am again in the near field. This improves the
propagation i suppose.
If my 5 km distance could be "utility assisted"
like in Rogers tests is not sure. A wider distance reception has to be
done!
After that i increased the earth antenna length to 500m, 420m
ground electrode spacing!! :-) The average height above ground is still
about 4m. Orientation of the antenna is N<=>S.
This was a hard work
since i had to climb many trees since i had to cross 2 ways in a hight of
about 6m. Since it is a conferous forest, i have 100s of scratches now but all
in all it was a inspiring work :-).
I removed the far ends ground rods and
will place them on the new end that will be found on thursday! Adding the last
200m part will be rather easy since there are no ways to cross any more and
the tree-density is rather low ;-) Than, i will have a 700m long wire and the
ground electrode distance will be about 600m!! With that antenna i will try to
be received in 50km distance on 8,97 kHz when Michael Oexner is coming back
from holidays in abt 2 weeks.
Before this test i will try to reduce the
overall losses below 500 Ohm and do some RX tests watching the new VLF
transmitter levels (DHO38 and so on).
Any bets about the signal
increase when increasing the spacing from 280m to 600m?
73,
Stefan/DK7FC
|
|
