Hello Graham,
thanks for the QSO's last night.
Under current conditions (lot of QRN and QSB) ThrobX2 seemes a bit better than
PSK31. MFSK4 wouldn't print last night.
The night before it was the same until all the sudden I had a perfect print.
Maybe tuning / synchronisation is rather critical for MFSK4.
The bandwidth of MFSK4 seems about 150Hz, so i will not use it for transmit.
PSK31 and ThrobX2 are well below 100Hz.
I will try to decode the signals starting 21:00 UTC.
73, Rik ON7YD - OR7T
Quoting Graham <[email protected]>:
Final set up , power ~ 30 watts per stream
same text , 60 sec repeat ..
PSK31 Cent audio 2200 Hz = 503.20k cent rf
MFSK4 Cent Audio 2000 Hz = 503,00k cent rf
ThrobX2 Cent Audio 1700 Hz = 502.70 k cent rf
Thanks for reports via email, throb, is showing well as it has 'no'
lock up time ?
Graham
--------------------------------------------------
From: "Graham" <[email protected]>
Sent: Sunday, May 10, 2009 7:40 PM
To: <[email protected]>
Subject: LF: 3 mode Beacon 503.00 502.700 503.2 1800 gmt > later
All,
Just added psk31 on 2200 hz audio
G ..
--------------------------------------------------
From: "Graham" <[email protected]>
Sent: Sunday, May 10, 2009 7:18 PM
To: <[email protected]>
Subject: LF: Dual mode Beacon 503.00 502.700 1800 gmt > later
All
Running MFSK 4 and ThrobX2
Tx set
Dial 501.000
mode usb
FLDIGI software
PSK31 Cent audio 2200 Hz
MFSK4 Cent Audio 2000 Hz
ThrobX2 Cent Audio 1700 Hz
Power 40 watts per stream
Running loop at 60 seconds repeat
No rx due to drive below vox/alc level
Reports welcome
Graham
G0NBD / IO83LK
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.287 / Virus Database: 270.12.23/2106 - Release Date: 05/09/09
06:54:00
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.287 / Virus Database: 270.12.23/2106 - Release Date:
05/09/09 06:54:00
|