Rik,
Open two instances of Multipsk, set the receiver to 501KHz USB.
On one Multipsk select MFSK16 & click the cursor at 1000 on the waterfall &
on the other Multipsk select Olivia then the Olivia mode to 8x500, button
just over the waterfall then click the cursor on 2000.
You should now be up & running both modes.
73
Gary - G4WGT.
-----Original Message-----
From: [email protected]
[mailto:[email protected]] On Behalf Of Rik Strobbe
Sent: 04 February 2009 21:32
To: [email protected]
Subject: Re: LF: Olivia 500 x 8 MFSK16 NOW RUNNING
Graham,
I just installed multipsk.
I believe it is the most chaotic programme I have ever seen.
Right now 21:28UTC I hear alternating signals on 502 and 503.
As I am not in the mood of reading the multipsk manual today could you
just tell me what mode is running where and what dial frequency / mode
(USB or LSB) I should set the RX to?
73, Rik ON7YD - OR7T
Quoting Graham <[email protected]>:
> Modes changed
>
> MT63 STOPPED
>
> MFSK16 , Centre freq 1000 Hz audio
>
> Approx 15 watts peak per stream
>
> Thanks for reports .. will run this config an hour or so
>
> G ..
>
> --------------------------------------------------
> From: "Graham" <[email protected]>
> Sent: Wednesday, February 04, 2009 7:39 PM
> To: <[email protected]>
> Subject: LF: If anyones about , MT63 x 500 Hz and Olivia 500 x 8
> running now 1935 hrs
>
>>
>> As a follow on to some tests with Gary , with Olivia 500 x 8 and the
>> original MT63 system
>>
>> Running two data streams now at about 10 watts per mode , carrier
>> frequencies are :-
>>
>> mt63 501.5 to 502 Khz
>>
>> olivia 500x8 503 Khz +/- 250 Hz
>>
>> The book says mt63 should not print as well as olivia .....
>>
>> tnx - G ..
>>
>>
>>
>>
>>
>>
>
>
>
>>
>> No virus found in this incoming message.
>> Checked by AVG - www.avg.com
>> Version: 8.0.233 / Virus Database: 270.10.17/1934 - Release Date:
>> 02/03/09 17:48:00
>>
Disclaimer: http://www.kuleuven.be/cwis/email_disclaimer.htm
|
