Dear Graham, LF Group,
Decoding your WOLF signal now - frequency appears to be 502.7980kHz, which
is quite a long way off nominal for this mode. It could be down to either TX
frequency accuracy, or sound card sample rate, or both. Both need to be
calibrated accurately for this mode to work properly.
I will run the M0BMU beacon again tonight from approximately 2230utc, WOLF
10 mode, 503.800kHz. Any reports would be welcome.
Cheers, Jim Moritz
73 de M0BMU
----- Original Message -----
From: "Graham" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 19, 2008 9:07 PM
Subject: Re: LF: Re: WOLF BEACON 502.800
> Ok wolf, looks like the set up is working ? might of been 'messing about'
> but its running now, hopefully should be ok , tx should be stable ,
> soundcard is a isa awe64 , been on 3 hors , so , see what happens ..
>
> Tnx
>
> G ..
>
>
> ----- Original Message -----
> From: "Hartmut Wolff" <[email protected]>
> To: "Graham" <[email protected]>
> Sent: Saturday, January 19, 2008 8:18 PM
> Subject: Re: LF: Re: WOLF BEACON 502.800
>
>
> > Graham,
> >
> >> Stopped at moment , unable to print localy from off air ... not sure
> >> with
> >> this mode .. local rx did not decode test message .... ???
> >> G ..
> >
> > I got only one decoded line here just after 19:30. The signal was
> > visible, but I saw many interruptions. QSB or tx off?
> >
> >
> > t: 24 f: 2.123 a: 0.9 dp:107.3 ci:12 cj:378 274G29C*BCP.UL7 ?
> > t: 48 f:-2.400 a:-0.1 dp:109.5 ci: 2 cj:165 G0NBD IO83LK * -
> > t: 96 f:-2.399 a:-0.3 dp:109.6 ci:13 cj:165 *AF67Y???2T3BE0 ?
> > t: 192 f:-2.402 pm: 2011 jm:631 q: -6.0 -8.8 9*/QSZ7B/GOX*VT ?
> > t: 288 f:-2.393 pm: 3160 jm:634 q: -5.8 -9.1 7/9MDENPJY.P OX ?
> >
> > 73
> > Hartmut
> > www.h-wolff.de
> > Locator: JO52hp
> >
> >
> >
> >
> >
> > --
> > No virus found in this incoming message.
> > Checked by AVG Free Edition.
> > Version: 7.5.516 / Virus Database: 269.19.7/1232 - Release Date:
1/18/2008
> > 19:32
> >
> >
>
>
>
>
|
