Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Re: WD2XSH/10 on 505.950 KHz 2200Z 29 OCT 06

To: "RSGB LF" <[email protected]>, "600MRG" <[email protected]>
Subject: LF: Re: WD2XSH/10 on 505.950 KHz 2200Z 29 OCT 06
From: "MIKE REID" <[email protected]>
Date: Sun, 29 Oct 2006 16:58:52 -0600
Delivered-to: [email protected]
Importance: high
References: <[email protected]>
Reply-to: [email protected]
Seal-send-time: Sun, 29 Oct 2006 16:58:52 -0600
Sender: [email protected]
Dex,
 
I see you and hear you fine on 505.95kc regular CW sending your ATT email address with 'at' instead of the @ symbol. It is 4:56pm CST right now. Receiver is a Cushman CE-24a on the #8 E/W loop tuned to 185.3kc. CW is slower than than a 'Possum crossin the road while he stares at the headlights...LOL!!!
 
 
Mike
WE0H
WD2XGI
WD2XSH/16
EN35hj
 
 
----- Original Message -----
From: Dexter McIntyre W4DEX
Sent: Sunday, October 29, 2006 3:05 PM
Subject: 600MRG> WD2XSH/10 on 505.950 KHz 2200Z 29OCT06

WD2XSH/10 will move back to 505.950 KHz tonight and will be sending slow CW
which will display good on Argo NDB slow mode.  The screen shots that both
Hartmut and EA1PX sent me from last night's run show short periods of good
QRSS10 copy and even noticeable copy of the CW ID.  With just a little better
propagation I believe they may copy 5 wpm with Argo NDB slow mode.

So far the QSB cycles for DX paths have shown to be to rapid for anything much
slower than QRSS10.  The 1 Hz separation between /11 and /10 last night was not
enough for this speed.  I should not have run that close to /11 last night but
had posted the schedule before trying to contact Conard.

START:  22ØØZ 29OCTØ6   END: APPROXIMATELY 13ØØZ 3ØOCTØ6   FREQ: 5Ø5.95Ø KHZ
MODE:  5 WPM CW ID/MESSAGE

WD2XSH/1Ø
<Prev in Thread] Current Thread [Next in Thread>