Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

LF: Amp led on

To: "Scott Tilley" <[email protected]>, "LF \(RSGB\)" <[email protected]>
Subject: LF: Amp led on
From: "J. Allen" <[email protected]>
Date: Sun, 6 Aug 2006 05:53:25 -0000
Delivered-to: [email protected]
References: <005001c6b913$cdd540a0$6501a8c0@eagles> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Scott,

I am sorry that it is necessary for you to repeat things to me. My memory has improved, but still has holes in it. For some reason, I keep re-solving the problems instead of remembering the correct answers. Please bear with me, and I am sure that you will be able to guide me to a working amp at 1W ierp. I just hope it happens before I drive you nuts.

Ok... first, I need to get your amp going and get the new problem worked out of the overcurrent circuit. The newly wound output transformer did not get a chance to transmit today. The transmitter was powered up by first turning on the 5 and 12 Volt auxiliary supplies, and the LED immediately came on, so the FET supply was left off until I can find out what is wrong there and fix it.

You mentioned that noise could be causing the overcurrent circuit to act up. Should I try putting bypass capacitors to ground on the 5 and 12 Volt inputs? This may reduce possible noise from the power supply lines.

When the amp works into the dummy, the tap is adjusted for 100 Watts output, or else I drag out a blanket with which to make smoke signals.

Thanks...

J.




<Prev in Thread] Current Thread [Next in Thread>