Hi Markus,
Thanks for the suggestion. I am currently using 16 turns of #10 wire for the
50 ohm side and 3 turns of rubber insulated 16 mm2 wire for the low impedance
loop side. I would have to use smaller diameter wire or a larger diameter core
to fit more turns in.
--
73 Warren K2ORS/WD2XGJ
FN42hi
http://www.w4dex.com/wd2xgj.htm
-------------- Original message ----------------------
From: [email protected]
Warren,
any chance to use a higher number of turns? Core loss should go down at least
proportional to their inverse square, hysteresis losses even with inverse
cube .
73 de Markus, DF6NM
In einer eMail vom 02.02.2006 23:42:46 Westeuropäische Normalzeit schreibt
[email protected]:
> I guess I need a bigger core than the 3 stacked FT-290-77s any suggestions
> out there?
>
|
