Return to KLUBNL.PL main page

rsgb_lf_group
[Top] [All Lists]

Re: LF: Off Topic Ft101zd

To: [email protected]
Subject: Re: LF: Off Topic Ft101zd
From: "captbrian" <[email protected]>
Date: Sun, 20 Feb 2005 20:44:17 -0000
References: <[email protected]> <[email protected]> <002b01c51775$96213ba0$56540150@p2300> <[email protected]> <[email protected]>
Reply-to: [email protected]
Sender: [email protected]
Aha , thank you. Of course I am by no means sure that my handbook is
specific to the rig I have.  I wondered if it had been omitted on some
models..

Bryan
----- Original Message -----
From: Niels Chr. Bahnson <[email protected]>
To: <[email protected]>
Sent: Sunday, February 20, 2005 8:07 PM
Subject: Re: LF: Off Topic Ft101zd


Niels Chr. Bahnson wrote:

> captbrian wrote:
>
>> this rig , which I prefer on HF to more modern ones,  has lost
>> sensitivity
>> if antenna is put to usual socket but is fine with Rx socket. That
>> implies
>> fuse-bulb gone. I am inside the case  but blowed if I can find the
bulb.
>>
>> Anyone know where it is ?
>>
>> Thank you
>>
>> Bryan
>> ----- Original Message -----
>> From: jannsen <[email protected]>
>> To: <[email protected]>
>> Sent: Saturday, February 19, 2005 9:18 PM
>> Subject: LF: 135922
>>
>>
>>
>>
>>> Hello group,
>>>
>>> DJ8WX is not on the air this night.
>>>
>>> regards
>>> Uwe/dj8wx/jo43sv
>>>
>>>
>>>
>>>
>>
>>
>>
>>
>>
>>
> Dr. Bryan
>
> From the Rx socket the signal also have to go through the bulb, so
> this can not be broken. It may rather be a dirty or broken contact in
> the antenna relay. The bulb is vy near the antenna relay and is of the
> socket-less type.
>
>    Hope you get it fixed, for as you said, the FT 101 ZD is really a
> good old stn.
>
>                                  Vy 73 de OZ7NB, Niels
>
>
       I just found out that it depends on the serial number whether the
signal from the Rx socket has to pass through the bulb  or not.
                                                                Vy 73 de
Niels





<Prev in Thread] Current Thread [Next in Thread>